User manual BOSCH SKS51E22EU

[. . . ] SK. . . 5HVHW  VHF       K K K 6WDUW    K K K           en Table of contents Intended use . 4 Before you switch ON the appliance Delivery. . 4 . 5 . 5 . 6 . 6 . 6 . 7 Height of utensils . 17 Express Wash/ Speed Perfect (VarioSpeed). [. . . ] Do not use sponges with a rough surface or abrasive detergents, as these could scratch the surfaces. Stainless steel appliances: To prevent corrosion, avoid using sponge cloths or wash them out thoroughly several times before using for the first time. Filters The filters 1* keep large foreign objects in the rinsing water away from the pump. These foreign objects may occasionally block the filters. The filter system consists of a coarse filter, a flat fine filter and a microfilter. After each washing cycle check the filters for residue. Unscrew filter cylinder as illustrated and take out filter system. 20 Fault, what to do?Remove any residue and clean filters under running water. Re-install filter system in reverse sequence and ensure that the arrow marks are opposite each other after closing the filter system. en Fault, what to do? , tu l F a w t a h o t d ?o Spray arm Limescale and dirt from the rinsing water may block nozzles and the bearing assemblies of the spray arm 1". Check outlet nozzles on the spray arm for blockages. Remove the spray arm upwards. Experience has shown that you can rectify most faults which occur in daily operation yourself. This ensures that the machine is quickly available to you again. In the following overview you can find possible causes of malfunctions and helpful information for rectifying them. Note If the appliance stops during dishwashing or does not start for no obvious reason, first run the Abort programme function (Reset). (See chapter entitled “Operating the appliance”) m Warning – Don’t forget: Repairs may be carried out by technicians only. If a component has to be replaced, ensure that only original spare parts are used. Improper repairs or use of non-original spare parts may cause considerable damage and put the user at considerable risk. 3. Clean the spray arm under running water. Lock the spray arm into position. 21 en Fault, what to do?Check inner compartment and remove any foreign objects. Place pump cover in the original position, press down and screw tight. Install filters. Waste water pump Large food remnants or foreign objects which were not captured by the filters may block the waste water pump. [. . . ] Water pressure: At least 0. 05 MPa (0. 5 bar), maximum 1 MPa (10 bar). At a higher water pressure: connect pressure-reducing valve ahead. Inlet rate: Minimum 10 litres/minute Water temperature: Max. temperature 25 °C Installation The required installation dimensions can be found in the installation instructions. [. . . ]