User manual BOSCH SMD50E12CH

[. . . ] Dishwasher 9000 405 277 (8811) en Instructions for use en Index 4 4 4 4 4 4 4 5 5 5 5 6 6 7 7 7 8 8 8 9 9 9 9 9 9 10 10 10 10 11 11 12 13 14 14 14 15 15 15 15 IntensiveZone . Remaining running time display Timer programming . Terminating the programme (Reset) Changing the programme . Overall condition of the machine Filters . [. . . ] Any escaping water vapour could damage sensitive worktops. Timer programming * * depending on model You can delay the start of the programme in 1-hour steps up to 24 hours. Press 6 button until the digital display 5 jumps to . Press button 6 until the displayed time corresponds with your requirements. Press Start button 4 , timer programming is activated. To delete the preselected starting time, is press the button 6 until indicated on the digital display. You can change your programme selection at any time until the programme starts. Interrupting the programme Switch off ON/OFF switch 1 . If the door was opened on an appliance which has a warm water connection or is heated, first leave the door ajar for several minutes and then close. Otherwise, expansion (pressure) may cause the appliance door to spring open or water to run out of the appliance. To continue the programme, switch on the ON/OFF switch 1 again. End of programme The programme has ended when the is indicated on the numerical value display 5 . Terminating the programme (Reset) Press START button 4 for approx. Switch off ON/OFF switch 1 . 16 en Changing the programme When the START button 4 has been pressed, the programme cannot be changed. The only way a programme can be changed is by Cancel programme (reset). Maintenance and care A regular inspection and maintenance of your machine will help to prevent faults. This saves time and prevents problems. Intensive drying The final rinse uses a higher temperature which improves the drying result. (Caution if utensils are delicate!) Close the door. Rotate programme selector 3 until is indicated on the digital display 5. (intensive The factory-set value drying off) is lit on the digital display 5. Change the setting as follows: By rotating the programme selector 3 , you can switch intensive drying on or off . The set value is saved. Overall condition of the machine Check spray arm for grease and limescale deposits. If you find such deposits: Fill detergent dispenser with detergent. Start the appliance without utensils in the programme with the highest rinsing temperature. Clean the appliance with detergents/ appliance cleaners which are particularly suitable for use with dishwashers. Regularly clean door seal with a damp cloth. Never use a steam cleaner to clean your dishwasher. [. . . ] holiday home), empty the appliance completely (see Transportation). Turn off the tap, disconnect supply hose and drain water. 24 en Waste disposal Both the packaging of new appliances and the old appliances themselves contain valuable raw materials and recyclable materials. Please dispose of the individual parts separated according to type. Please ask your dealer or inquire at your local authority about current means of disposal. Packaging All plastic parts of the appliance are identified with internationally standardised abbreviations (e. g. [. . . ]