User manual BOSCH SMI 40D06EU/25 SUPPLEMENT

[. . . ] To ensure optimal and regular performance of your appliance please read this instruction manual carefully. It will enable you to navigate all processes perfectly and most efficiently. To refer to this manual any time you need to, we recommend you to keep it in a safe place. And please pass it to any future owner of the appliance. [. . . ] To deactivate the function press the 3 IN 1 button again: the indicator light turns off. If the drying results are not satisfactory we suggest that you: 1. Fill up the rinse aid dispenser with rinse aid. · The activation/deactivation of the rinse aid dispenser can only be possible with the "3 IN 1 function" active. Activation/deactivation of the rinse aid dispenser 1. Press simultaneously buttons B and C, until the lights of buttons A , B, and C start flashing. Press button B, the lights of buttons A and C turn off while the light of button B goes on flashing: the end of programme indicator light illuminates, indicating that the rinse aid dispenser has been activated. To change the setting, press button B again until the end of programme indicator light turns off. To memorise the operation, switch off the dishwasher by pressing the On/Off button. If you decide to turn back to the use of standard detergent system we advise that you: 1. Deactivate the "3 IN 1 function". In this case you have to set the washing programme again. If a new washing programme is to be selected, check that there is detergent in the detergent dispenser. Interrupt or cancel a washing programme in progress ONLY if it's absolutely necessary. Hot steam may escape when the door is opened. Interrupt a washing programme in progress: · Open the dishwasher door; the programme will stop. Close the door; the programme will start from the point at which it was interrupted. · Press the On/Off button, all lights will turn off. Press the On/Off button again; the programme will start from the point at which it was interrupted. End of the washing programme · The dishwasher will automatically stop. · The audible signal will inform you of the end of programme. · The end of programme indicator light will illuminate. [. . . ] Ensure the hose is not bent or squashed as this could prevent or slow down the discharge of water. The sink plug must not be in place when the machine is draining as this could cause the water to syphon back into the machine. 36 Installation If you use a drain hose extension it must be no longer than 2 metres and its internal diameter must be no smaller than the diameter of the hose provided. Likewise the internal diameter of the couplings used for connections to the waste outlet must be no smaller than the diameter of the hose provided. When connecting the drain hose to an under sink trap spigot, the entire plastic membrane (A) must be removed. [. . . ]