User manual BOSCH SMI 50E86EU/36 SUPPLEMENT
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual BOSCH SMI 50E86EU/36. We hope that this BOSCH SMI 50E86EU/36 user guide will be useful to you.
Lastmanuals help download the user guide BOSCH SMI 50E86EU/36.
Manual abstract: user guide BOSCH SMI 50E86EU/36SUPPLEMENT
Detailed instructions for use are in the User's Guide.
[. . . ] Please read the section on "Installation" to make sure you know all about this. Before using your dishwasher for the first time, do not forget that the nominal voltage and current type indicated on the rating plate of your machine must be the same as the nominal voltage and current type at the installation site. The necessary electrical fusing is also given on the rating plate.
Packaging parts (e. g. foils, styrene foam) may be dangerous for children, who could even be suffocated! [. . . ] The storage compartment built in to the in side of the door can hold about 110 ml of rinse-aid, which will be sufficient for between 16 and 40 dish-washing programmes, according to the dosage setting.
Filling up the rinse-aid
Open the container by turning the lid (A) anticlockwise (Fig. Pour the rinse-aid into the filler opening until the indicator (B) on the side of the cover turns completely dark (i. e. until the container is full)
Rinse-aid replenishment indicator Top up with rinse aid when the rinse aid control light on the control panel flashes (approx. Clean up any rinse aid spilt during filling with an absorbent cloth to avoid excess foaming during the next wash.
Setting the rinse-aid quantity to be added
The correct dosage of the rinse-aid should be regulated on the basis of the shine and drying results. For this purpose, set the quantity of liquid by means of the six-position selector (C) located on the inside of the filler opening (minimum quantity is position 1, maximum quantity is position 6). If drops of water or white marks remain on the crockery after it has been washed, gradually increase the dosage. If the crockery comes out with whitish, sticky streaks, reduce the dosage.
Adding dishwashing detergent
Use only tablets, powder or liquid detergents specifically designed for domestic dishwashers. Before starting any of the dishwashing programmes, except for the rinse and hold programme, load the detergent in the dispenser. To help you to correctly dose the right amount of detergent, inside the container there are two reference marks: - MIN = 15 ml - MAX = 30 ml
Fig. To prevent the full cutlery basket from inadvertently unfolding when being taken out, place your hand right round the two-piece handle and hold it firmly. Ë Place the cutlery basket on a firm support (table, worktop) and unfold both handle parts. Ë After unfolding, fold back both handle parts.
The upper basket
The upper basket is designed for plates (dessert plates, saucers, dinner plates up to 24 cm in diameter), salad bowls, cups and glasses; these should be arranged as shown in the pictures. Glasses with long stems can be placed upside-down in the raised cup-racks
IEC 436 / DIN 44990
IEC 436 / DIN 44990
Fig. 15 (9 IEC)
The cup-rack on the left folds upwards to increase your loading flexibility.
Before closing the door, ensure that the spray arms can rotate freely.
Adjusting the height of the upper basket
If washing very large plates (over 27 cm and up to 31 cm in diameter) you can load them in the lower basket after moving the upper basket to the higher position as follows: Move the front runner stops (A) of the upper basket outward and slide the basket out. Refit the basket in the higher position and replace the stops (A) in their original position.
When the top basket is in the higher position it will only take plates up to 20 cm in diameter and you will not be able to use raised cup racks.
Set and start the programme
Push the plug into the socket. Press the button corresponding to the selected programme; in the display appears the duration of the programme in minutes. The following lights will illuminate: selected programme, the phases under way of the programme selected, "door" control light. The control lights of "rinse-aid and "salt" may also illuminate if refilling is necessary. [. . . ] In all cases, this must be properly arranged to prevent subsequent damage to the worktop. the protection should be arranged according to the instructions given on the template. When installing the dishwasher in the recess, please make sure that the drain hose, supply hose and electrical supply lead are arranged so they can move freely in the rear plinth area and so that any kinking or squashing of these connections leads is prevented.
Connecting the water supply
Your dishwasher has been built in accordance with the valid regulations governing water-consuming appliances and is equipped with safety devices which prevent used water from flowing back into the drinking water mains. Your dishwasher can be connected to either a cold or hot water supply of max. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE BOSCH SMI 50E86EU/36
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets...
In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.
Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual BOSCH SMI 50E86EU/36 will begin.