User manual BOSCH SMI 63M52EU/75 SUPPLEMENT

[. . . ] This warranty gives you specific legal rights, and you may have other rights which vary from state to state. Sears, Roebuck and Co. , D/817 WA, Hoffman Estates, IL 60179 If you want your water softener professionally installed, talk to your Sears Salesman. He will arrange for a prompt, quality installation by Sears Authorized Installers. SEARS INSTALLATION POLICY All installation labor arranged by Sears shall be performed in a neat, workmanlike manner in accordance with generally accepted trade practices. Further, all installations shall comply with all local laws, codes, regulations, and ordinances. [. . . ] Then fill the tank with nugget or pellet salt only. FIG. 9 SALT BRIDGE push tool into salt bridge to break 1" ­ 2" Pencil Mark Broom Handle Salt Salt Bridge Water Level 14 SECTION 3 3B. CARE OF YOUR SOFTENER KEEPING THE WATER SOFTENER CLEAN NOTE: Never use cleaners having ammonia or abrasives. They may scratch and dull the surface. COVERS To keep your new Sears water softener looking nice, apply a coat of paste wax and repeat once a year. When dusty, wipe it with a damp cloth to keep it sparkling. NOZZLE AND VENTURI A clean nozzle and venturi (FIG. 10) is a must for the softener to work right. This small unit moves brine from the salt storage tank to the resin tank during regeneration. If it becomes plugged with sand, silt, dirt, etc. , the softener will not work and you will get hard water. To get to the nozzle and venturi, remove the softener top cover. Be sure the softener is in service cycle (no water pressure at nozzle and venturi). Then, holding the housing tightly with 1 hand, turn the cap off. If a single bypass valve is installed, move the stem into bypass. In a 3 valve bypass system, close the inlet and outlet valve and open the bypass valve. If you want water in the house pipes again, reopen the shut off valve on the main water pipe. Unplug the transformer at the wall outlet. Remove the salt hole cover and the main cover. Carefully remove the large holding clips at the softener inlet and outlet (see Key No. Separate the softener from the adaptors or bypass valve. Remove the brinewell cover and disconnect the brine valve tubing at the nozzle and venturi assembly (see page 23). Lift the brine valve out of the brinewell. Tip the brine valve upside down to drain out water. 8. 11, lay a piece of 2 inch thick board near the floor drain. [. . . ] The valve remains positioned in service until the timer initiates the next regeneration. 26 SECTION 5 NOTES SERVICE TECH. INFORMATION 27 SECTION 6 REPAIR PARTS SEARS WATER SOFTENERS MODEL NOS. SMI 63M52EU/75 AND 625. 348490 KEY PART NO. NUMBER DESCRIPTION 1 7137604 Cover (main) 2 7137612 Salt Hole Cover 3 7118333 Wire Harness (switch) 4 7084330 Power Cord (transformer) 5 7144960 Timer Repl. [. . . ]