User manual BOSCH SMS53A12GB

[. . . ]     K 5HVHW  VHF % K PLQ $ K 6WDUW & 5HVHW VHF                    en Table of contents Intensive zone . Switching off automatically after the end of the programme . Protection against frost (Emptying the appliance) . 17 17 17 17 17 17 18 18 18 18 18 19 19 19 19 20 20 20 20 21 21 22 22 22 22 23 23 24 25 25 25 25 26 26 26 26 27 27 27 27 28 28 28 Safety instructions . [. . . ] When the appliance has been restarted, the remaining running time is indicated again during the rinsing phase. nargoTiep m theprgomyarthnfeonlhSwticigoutm a aefd Switching off automatically after the end of the programme * * depending on model To save energy, the dishwasher is switched off 1 minute after the programme ends (factory setting). Automatic disconnection can be adjusted from : to : . Appliance does not switch off automatically : Off after 1 min : Off after 120 min – Close the door. – Hold down programme button # and press START button P until : . . . The LED for button # flashes and the digital display )" displays the factory setting : . – Press programme button # until the factory set value : is indicated on the digital display )". To change the setting: – Press programme button 3. Each time the button is pressed, the set value increases by one level; when the value of : has been reached, the display jumps back to : (off). : Timer programming * * depending on model You can delay the start of the programme in 1-hour steps up to 24 hours. – Press button @ + until the digital display )" jumps to : . – Press @ + or – button until the displayed time corresponds with your requirements. – Press START button P, timer programming is activated. – To delete timer programming, press the @ + or – button until )" : is indicated on the digital display. You can change your programme selection at any time until the programme starts. Switching off the appliance Short time after the end of the programme: – Switch off ON/OFF switch (. – Turn off the tap (not applicable if AquaStop fitted). – Remove the utensils when they have cooled down. End of programme The programme has ended when the value : is indicated on the numerical display )". The following applies to TurboSpeed 20 min. : As soon as : is indicated on the digital display )", the rinse cycle has ended. When the appliance door has been opened, p is indicated on the digital display. If no further rinse cycle is required, switch off the appliance with the ON/OFF switch (. 18 en ã=Warning Intensive drying The final rinse uses a higher temperature which improves the drying result. (Caution if utensils are delicate!) – Close the door. – Hold down programme button # and press START button P until the digital display )" : . . . [. . . ] – Use only a residual current operated circuit-breaker which features the symbol ‚. Only this extension guarantees compliance with the currently valid regulations. – The appliance features a water damage protection system. Please note the system will not function unless the power supply is connected. Transportation Empty the dishwasher and secure loose parts. [. . . ]