User manual BOSCH SRI3015

[. . . ] Household Appliances Internet: http://www. bosch-hausgeraete. de Bosch Info-Team: DE Tel. DTAG) 5600 053 180 (8211) en Instructions for Use en Index 4 6 7 8 9 10 11 Detergents . 13 15 16 17 19 21 21 22 Safety instructions . Getting to know your appliance Water softener . [. . . ] If only a small number of dishes have been loaded into the dishwasher, selecting a programme that operates at the next lowest temperature will usually suffice. 15 en Programme data The programme data (duration, energy and water consumption) can be found in the summary of instructions and refers to standard conditions. Greater deviations may be caused by: different quantities of utensils inlet temperature of the water water pressure ambient temperature mains voltage tolerances and appliance-specific tolerances (e. g. temperature, water flow rate, etc. ) The water consumption values refer to water hardness value 2. Washing the dishes Switching on the appliance Turn on the tap fully. Check once again that the spray arms can rotate freely. Select a programme with the programme selector 1 (rotate in a clockwise direction only). The programme starts. Programme sequence indicator While the dishes are being washed, the programme selector rotates in a clockwise direction and indicates how far the programme has progressed. End of programme The programme has ended when the pump noise is no longer audible and the programme selector has reached its initial position (12 o'clock position). Switching the dishwasher OFF Several minutes after the programme has ended: Set the main switch 5 to OFF. (Does not apply when Aqua­Stop unit has been fitted) It is not necessary to reset the programme selector. when they have cooled down. 16 en Interrupting the programme Set the main switch 5 to OFF. If the hot water was switched ON or the appliance has already heated up and then the appliance door opened, leave the door ajar for several minutes and then close. Otherwise, the appliance door may fly open due to expansion. In order to resume the programme, set the main switch to ON again. Maintenance and care You can help prevent faults by checking and maintaining your appliance regularly. This will save time and reduce problems. Therefore you should occasionally examine the inside of your dishwasher. Overall condition of the appliance Check the rinsing compartment for grease and limescale deposits. If you find any deposits: Fill the detergent dispenser with detergent. Start the empty appliance with the programme which has the highest rinsing temperature. Clean the door seal: Wipe the door seal regularly with a damp cloth and remove any deposits. Changing the programme Switch off the main switch 5 . Set the programme selector 1 to the new programme (rotate in a clockwise direction only!). Check whether the detergent dispenser is still closed. Note If the power supply is disconnected while the appliance is operating, e. g. by switching off the appliance or due to a power failure, all settings remain stored. Operation continues automatically as soon as the power supply is restored. Dishwasher salt Check the LOW SALT indicator up with salt, if required. 24 . Top Rinse-aid Check the level of liquid in the rinse-aid container 30 . [. . . ] Ensure that the fresh water connection is not kinked, crushed or twisted. Water pressure: Minimum 0, 5 bar ­ maximum 10 bar. If the water pressure is higher, install a pressure reducing valve. Flow rate: Minimum of 10 litres per minute. [. . . ]