User manual BOSCH TDS4570GB

[. . . ] En Thank you for buying the sensixx B45L steam station, the new steam-ironing system from Bosch. Carefully read through the operating instructions for the appliance and keep them safe for future reference. Uk for more product information or to register your product, just follow the link to the Online guarantee registration. An authorised Technical Service Centre before it can be used again. [. . . ] By default, the steam station automatically chooses the “auto” steam setting. The steam setting can be changed by the user by changing the temperature. The steam station will propose the suitable steam level automatically depending on the temperature selection made. Temperature icon on display Steam setting If necessary, the steam level can be adapted to your needs by touching the (8). Icon on the display The water drops will disappear after you have used the function for some time. Ironing without steam This enables the iron to be used for dry ironing. Begin ironing but without pressing the steam release buttons (13-14*). The selected icon flashes until the pressure corresponding to each steam level is reached. Descaling the filter and the boiler (F) (Calc’n’Clean) To extend the life of your steam generator and to avoid any build up of scale, it is essential that you rinse out the filter (12) and the boiler after a period of use (approximately after 50 hours). If the water is hard, increase the frequency. Do not use descaling agents for rinsing out the boiler, as they could damage it. If the “ ” icon flashes, this indicates that the boiler must be rinsed. Check carefully that the appliance is cold and unplugged for more than 2 hours, and that the water tank (1) is empty. Lean the appliance on the opposite side of the filter opening. Unscrew the filter (12) and take it out. To wash the filter, you may: “secure” auto shut-off (model dependent) If during ironing, the steam release button (1314*) on the iron handle is not pressed for a certain length of time (8 minutes), the steam station will automatically switch off. The “ ” icon will flash when auto shut-off has been activated. To switch the steam station back on, press the steam release button again. Place the filter under the water tap and wash it until calc residues are removed. Squeeze the filter as indicated in the picture F. Immerse the filter in tap water (250 ml) mixed with a measure (25 ml) of descaling fluid. Rinse filter thoroughly before placing it back into the boiler The descaling fluid can be obtained from our After-sales service or from our website. [. . . ] €¢ Water tank (1) is not correctly inserted in the housing. €¢ The sound will not stop. The ironed garment turns dark and/or sticks to the soleplate. 12 en Problem Loss of pressure during ironing. [. . . ]