User manual BOSCH WAS32462GB/23 SUPPLEMENT

[. . . ] 4 5 6 7 8 10 11 12 15 16 18 22 24 25 27 32 35 36 37 Installation Instructions Installation, Connection and Transport . . 3 General The new washing machine which you have just purchased is a modern, high quality domestic appliance. Your washing appliance is distinguished by its eco nomical consumption of power, water and detergent. Each washing machine which leaves our factory has undergone a thorough performance test and is in fully working order. [. . . ] At the end of the additional programme turn the programme selector to Off. If the loading door cannot be opened: q Wait aprox. (the safety function is active) or q there is still water in the washing machine if the Rinse hold option was selected. Caution Remove any foreign objects (e. g. coins, paper clips) from the drum and rubber seal - risk of rust!i Leave the loading door open to allow the inside of the washing machine to dry out. Unloading the laundry 24 Special Applications Pre soak 1. Add the presoak agent to chamber II according to the manufacturer's specifications. Turn the programme selector to 30 °C Cottons+Linens. 15 minutes, turn the programme selector to Off. The laundry is left to lie in the water. Select a programme after the desired soaking period. Follow the ma nufacturer's instructions. Never use steel wool. 27 Cleaning the deter gent dispenser In the event that residual detergents or additives have accumulated: 1. Pull out the detergent dispenser up to the end stop, press down the hollow on the insert and remove the detergent dispenser completely. 2. Clean the detergent dispenser and insert under running water. 4. Attach the insert and lock into position. Insert the detergent dispenser. 28 Cleaning the drain pump This is necessary if the washing solution has not been completely drained. The pump is blocked by either loose debris or fluff which accumulates if fluff giving fabrics are washed. Draining the washing solution i Up to 20 litres / 4. 4 gal. Fold down the cover panel. 90 °C max. 3. Unscrew the pump cap slightly until the washing solution slowly begins to run into the cover plate cavity. When the cover plate cavity is half full, tighten the pump cap and empty the cover plate cavity. [. . . ] q A pressure reducing valve must be installed if the maximum water pressure is exceeded. 42 Connect the water supply hose 1. to the rear panel of the washing machine and . . . 2. Turn on the water tap completely, and check connection points for water tightness. 43 Water drainage Caution Do not bend or pull the water drainage hose. Height difference between the placement area and drainage point: maximum 100 cm. Drainage into a siphon: 1. [. . . ]