User manual BOSCH WBB24750

[. . . ] 2 Table of Contents Your Bosch washing machine . Remove the transportation safety devices . Before using your washing machine for the first time . Dispensing the correct amount of detergent . [. . . ] Time deviations are caused by: load amount Multiple spinning if the laundry is distributed poorly in the drum. Additional rinse cycle if excessive foam is in the laundry. too low water pressure Selection of an additional option, e. g. Rinse Plus K, after the programme has started, Washing with standard settings The specified standard settings are optimally adjusted to the selected programme. If you do not want to change these standard settings: q If required, press the button(s) for additional option(s). The indicator light of the selected button is on (red). inadvertently selected - the indicator light of the selected button goes out and a signal is emitted. i If an illogical combination was As a result of this and other properties, the wash time changes accordingly. i If no additional options were selected and if no other changes occur, the wash cycle will end at the indicated time. q Turn the tap on. q Press the Start/Pause M button. indicated in the display field. i The programme progress is q Turn the programme selector to the desired programme. Washing with individual settings is described subsequently. q Load the laundry and close the loading door. The Start/Pause M indicator light flashes (red). 18 Washing with individual settings You can adjust the settings to your requirements. First find a quick overview of the adjustable settings. The steps for changing the settings are described in detail overleaf. Programme Overview Select programme with programme selector. Load the laundry and close the loading door Press the Menu button. Spin speed Page 20 Dependent on programme and model, see P. 16 Programme finished at Page 20 Adjustable in 30 minute steps Wash Page 21 Normal Quick Intensive Signal Page 22 off continuous maximum Child lock: Page 22 off on Set clock: Page 23 Hours/ minutes Press Select button until desired setting is obtained. Press the Menu button for more settings or press Start/Pause M button. 19 Spin speed The speeds can be changed. The maximum displayed spin speed depends on the selected programme. q q Turn the programme selector to the desired programme. Load the laundry and close the loading door. The Start/Pause M indicator light flashes (red). Programme finished at i Make sure that the time has been set - see Set clock", Page 23. q q q Press the Select button until the desired spin speed or Without final spin" is displayed. Turn the programme selector to the desired programme. Load the laundry and close the loading door. The Start/Pause M indicator light flashes (red). Example: Other settings can be selected by pressing the Menu button; the same settings can be changed by pressing the Select button. Example: q q Press the Menu button until Spin speed" is displayed. The Start/Pause M indicator light flashes (red). [. . . ] Clean drainage pipe and/or drainage hose. Check whether laundry is trapped in door. Close the door. If the fault cannot be rectified with the aid of the above table: switch off the appliance, wait 5 seconds, then switch on the appliance, select and start the programme. If the fault recurs, call Customer Service, see Page 32. 31 Consumption values Additional option Load up to p p Cancelling the programme Cottons + Linens y 30 ºC Cottons + Linens y 40 ºC Cottons + Linens y 60 ºC Cottons + Linens y 60 ºC Cottons + Linens y 90 ºC Synthetics A 30 ºC Synthetics A 40 ºC Synthetics A 60 ºC Ay Mix 30 ºC Delicates/Silk J 30 ºC Hand wash/u Wool 30 ºC * Consumption values** Power Water 95 l 95 l 95 l 69 l 95 l 110 l 70 l 70 l 70 l 50 l 52 l 40 l Duration 1:45 h 2:00 h 2:30 h 2:30 h 2:10 h 3:40 h 1:20 h 1:20 h 1:50 h 1:00 h 0:50 h 0:30 h 0, 7 kWh 1, 2 kWh 1, 6 kWh 1, 7 kWh 1, 5 kWh 3, 2 kWh 0, 3 kWh 0, 5 kWh 0, 7 kWh 0, 2 kWh 0, 2 kWh 0, 2 kWh Intensive Wash" 9. 0 kg Intensive Wash" 9. 0 kg Intensive Wash" 9. 0 kg 8. 0 kg Cottons + Linens y 60 ºC v Stains* Intensive Wash" 9. 0 kg Intensive Wash" 9. 0 kg Intensive Wash" 4. 0 kg Intensive Wash" 4. 0 kg Intensive Wash" 4. 0 kg Intensive Wash" 4. 0 kg Intensive Wash" 3. 0 kg 2. 5 kg Programme setting with Intensive Wash" additional option for conducting test in compliance with EN 60456 and IEC 60 456 ** 9 kg load is recommended only in combination with the Intensive Wash" option. [. . . ]