User manual BOSCH WOL1650IL

[. . . ] WOL 1650 en Instruction Manual Internet: http://www. bosch-hausgeraete. de Table of Contents Disposal Information . Environmental Protection / Conservation Issues . 3 4 5 6 8 Before Using Your Washing Machine For the First Time . [. . . ] Washing solution or rinsing water is drained prior to the spin cycle. Drain Draining of the rinsing water after a wash programme with the Rinse hold" setting for the gentle treatment of delicate laundry. Spin speed selector Basic setting (Spin speed selector pointing upward) In the Cottons + Linens", Easy care" and Wool lens" programmes the fabrics will be spun at the ma ximum possible spin speed. In the Delicates" programme a lower spin speed will automatically be used, regardless of the position of the spin speed selector - for the gently washing of the laundry. Maximum spin speeds Revolutions per minute 800 800 600 800 800 800 Type of laundry / Extra cycle Cottons + Linens Easy care Delicates Woollens Rinse Spin C Washing remains in the last rinsing water. Start the "Drain" or "Spin" programme. The washing can also be removed dripping wet. Set the programme selector to "Off" and wait approx. 2 minutes. 21 Option buttons 1 Special spin cycle with post spin loosening cycle. The laundry is left lying loosely in the drum, thus reducing creasing. Observe the maximum load for each type of fabric; Remove the laundry immediately after the Spin cycle. r An additional rinsing cycle is performed; The washing duration will be prolonged accordingly. Recommended application: In areas with very soft water. D Reduced washing duration - only 2 rinsing cycles. Recommended load amount: Up to a maximum of 3 kg. Unbalanced load detection system The automatic unbalanced load detection system spins the washing several times to ensure even distribution. In the woollens programme the washing is spun only twice to prevent matting. If the washing is very unevenly distributed, the machine will not spin. 22 Washing q Turn on the water tap. Start the programme q Turn the programme selector to the desired pro gramme (refer also to separate Programme Chart"). The Ready" control light comes on. q Select the desired spin speed or C". q Where required, press the option button(s) for additional function(s). 23 q Press the 3" button. The Active" control light comes on, and the pro gramme starts. The Active" control light remains lit for the entire duration of the programme. Changing a programme If you have accidentally selected the wrong programme: q Turn the programme selector to Off". q Turn the programme selector to the desired programme. The Active" control light comes on, and the new programme starts. Cancelling active programme If you wish to prematurely end a programme: q Turn the programme selector to Off". q Turn the programme selector to Drain" or Spin". [. . . ] Reduce detergent dosing for the next wash cycle. 35 Fault Motor noise Cause Action Not a fault. Noises may be generated during the running in phase of the drive motor. Noises generated when the pump starts up or draws air are normal. Programme not ended or "C" selected. [. . . ]