User manual BOSCH WTA3510UC-II

[. . . ] AXXIS WTA 3510 Electric Vented Dryer AXXIS WTL 5410 Electric Condensation Dryer Use and Care Manual Installation Instructions Internet: http://boschappliances. com 2 Quick Reference Index Use and Care Manual IMPORTANT SAFETY INSTRUCTIONS . CYCLE SELECTION CHART (Recommendations) . STATEMENT OF WARRANTIES BOSCH CLOTHES DRYERS . 4 5 6 6 7 7 7 7 8 8 8 11 11 11 12 12 12 13 14 14 Installation Instructions Introduction . [. . . ] Do not attempt to repair the appliance yourself. Any work performed by unauthorized personnel may void the warranty. If you are having a problem with your Bosch dryer and are not pleased with the service you have received: l Please be sure to include, if writing, or have available, if calling, the following information: l l l l l Model Number Serial Number Date of Original Purchase Date Problem Originated Explanation of Problem First, please contact your installer or the Bosch Authorized Service Contractor in your area and explain to them why you are not satisfied. If after working with your installer or service person the problem still has not been resolved to your satisfaction, please let us know by either writing to us at, BSH Home Appliances 5551 Mc Fadden Avenue Huntington Beach, CA 92649 or, calling us at, Also, if writing, please be sure to include a daytime telephone number and a copy of the sales invoice. You will find the model number and serial number information on the rating plate located on the inside of the door above the lint filter. See Figure 1. l 1-800/944-2904. 12 SELF-HELP Dryers may exhibit problems that are unrelated to a malfunction of the dryer itself. The following table may serve to answer your question about a problem you are having without having to call a serviceman. PROBLEM ``On/Off'' Indicator light does not come on POSSIBLE CAUSE l The ``On/Off'' has not been depressed. l A fuse may have blown or a circuit breaker tripped. Replace fuse or reset circuit breaker at your fuse box/breaker box. l The plug is not correctly or only loosely inserted into the receptacle. l l Dryer does not start Cycle has not been selected. `Start'' button has not been depressed. l Room temperature is below 32 °F (0 °C) l If necessary, switch the machine off and wait 5 seconds before switching it on again. Select the cycle again and depress `Start''. l Cycle is interrupted and ``Lint Filter'' light is illuminated and buzzer sounds Clean Lint Filter as described in section titled CARE and CLEANING. l (WTA models) Check exhaust vent to see if it is blocked or too long. l (WTL models) Clean heat exchanger as described in section titled CARE and CLEANING. l (WTL models) Check air inlet to make sure it is not blocked. l Cycle is interrupted, buzzer sounds, one or several cycle indicators are flashing Drying level not reached or drying time too long The laundry is not dry even though the highest drying level has been selected Indicates faulty operation: ­ Clean the Lint Filter, check the exhaust duct length (WTA models), ­ Switch the dryer off, wait for it to cool down and then restart. l Clean the Moisture sensors in the drum as described in section titled CARE and CLEANING. l If there is a power failure for an extended period the cycle must be restarted. l l l l l l The drum is too full. The laundry was too wet when placed in the dryer. Make sure there is an adequate supply of fresh air. The lint filter is blocked and should be cleaned. (WTA models) The exhaust vent is blocked or too long. [. . . ] Attach the two remaining power cord outer conductors to the 2 terminals labeled L. Tighten both screws so that the power conductors are securely held in place. strain relief so that the power cord cannot be moved. 3-wire receptacle (10-30R) Typical 3-wire Dryer Cord 240V/30 amp NEMA 10-30 Type SRDT Figure 19. Note: If the dryer is installed in a mobile home or in areas where local codes do not permit grounding, only a 4-wire power supply cord shall be used. 21 Additional Grounding Procedure Some local codes may require a separate ground. [. . . ]