User manual BOSE 2.2 DIRECT REFLECTING

[. . . ] Unauthorized alterations may compromise safety, regulatory compliance, and system performance. The complete Declaration of Conformity can be found at www. The lightning flash with arrowhead symbol, within an equilateral triangle, alerts the user to the presence of uninsulated dangerous voltage within the system enclosure that may be of sufficient magnitude to constitute a risk of electric shock. The exclamation point within an equilateral triangle alerts the user to the presence of important operating and maintenance instructions in this owner's guide. [. . . ] Unplug this apparatus during lightning storms or when unused for long periods of time ­ to prevent damage to this product. Servicing is required when the apparatus has been damaged in any way: such as power supply cord or plug is damaged; liquid has been spilled or objects have fallen into the apparatus; the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped ­ Do not attempt to service this product yourself. Opening or removing covers may expose you to dangerous voltages or other hazards. Please call Bose to be referred to an authorized service center near you. To prevent risk of fire or electric shock, avoid overloading wall outlets, extension cords, or integral convenience receptacles. Do not let objects or liquids enter the product ­ as they may touch dangerous voltage points or short-out parts that could result in a fire or electric shock. Use proper power sources ­ Plug the product into a proper power source, as described in the operating instructions or as marked on the product. Information about products that generate electrical noise If applicable, this equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, this is no guarantee that interference will not occur in a particular installation. To skip to the beginning of the previous track, press twice. to skip to the next track , press Track Seek (forward) once. To quickly scan through a track, press and hold. To skip forward to the next playlist, press Playlist Select Forward (up pointer). To let your iPod charge while another audio device plays, press and hold Play/Pause (see page 5 for more information). Playing a different audio device You can use another audio device with your SoundDock® Series II digital music system. Playing a different audio device while charging the iPod You can charge your iPod while playing another audio device that is plugged into the AUDIO INPUT connector. Set the audio device to slightly below full volume, then Insert your iPod into the dock. Set the audio device to slightly below full volume, then Note: The SoundDock remote cannot control any device connected To enable the other device to play through the system, When the remote stops operating or its range seems reduced, it is time to change the remote battery. This insert can accommodate most iPod models. For a custom fit, use your insert supplied by Apple. [. . . ] Wipe off the small lens on the front end of the remote with a clean, dry cloth. ⷠMake sure there is a clear pathway between the remote lens and your SoundDock system. Your SoundDock does not respond to any controls Unplug the power cord for one minute, then plug it back in. This resets the system (you should hear a tone when the system is powered back on). [. . . ]