User manual BOSE CINEMATE SERIES I

[. . . ] CINEMATE TM DIGITAL HOME THEATER SPEAKER SYSTEM Français Español English SAFETY INFORMATION Please read this guide Please take the time to follow the instructions in this guide carefully. It will help you set up and operate your system properly and enjoy all of its advanced features. Please save this guide for future reference. The Interface module is to be used only with the Acoustimass® module in the Bose® CineMateTM speaker system. [. . . ] If you do not have the option of selecting either Fixed or Variable, turn off the TV speakers (see "Turning off the TV internal speakers"), exit the audio menu, and adjust the TV volume to about 80% of the highest volume. 13 Français SYSTEM SETUP Español English Installing or replacing the remote batteries SYSTEM SETUP 1. On the back of the remote, slide open the battery compartment. If you are replacing batteries, remove and discard the old batteries. Insert two new AA (IEC-R6) 1. 5V batteries, or their equivalent, as shown in Figure 15. (Two AA batteries are supplied in the product carton. ) Match the plus (+) and minus (­) marked on the batteries with the plus (+) and minus (­) inside the battery compartment. Slide the battery compartment cover back into place. Note: Replace the batteries when the remote control stops operating or its range seems reduced. Figure 15 Installing the remote control batteries (2) AA batteries (IEC-R6) + + Battery compartment cover Setting up the remote to control other sources The universal remote control provided with your CineMateTM speaker system can be programmed to control your TV, cable/satellite box, VCR, DVD player, and Digital Video Recorder (DVR) such as TiVo brands or ReplayTV brands. With the CineMate universal remote, you can enjoy the convenience of using only one remote control for all your home theater equipment. Finding device codes In order to control your TV and other sources with the universal remote control, you must program the remote with a five-digit device code for each source. To find device codes for your source, see the CineMate Universal Remote Device Codes book included in the product carton. Note: More than one code may work with your particular brand of device. If you notice a lack of response or limited functionality after setting up the remote, try a different code. To control your TV The steps below show how to set up the remote to control your TV. To set up the remote to control other sources, you will need to follow the same procedure, using the appropriate device code and source button for each source. Locate the TV section in the CineMate Universal Remote Device Codes book. Locate the five-digit device code(s) for your brand of TV and start with the first one. Press and hold Setup on the remote until all five source buttons light up. 14 English Español Français SYSTEM SETUP 4. Only the TV source button will remain lit. On the remote keypad, enter the first device code for your brand of TV. Check that the TV source button blinks twice and turns off after the code is entered. Point the remote at your TV and press TV On-Off. If your TV does not respond, go back to Step 1 and try another code. Follow the same procedure for each of your other sources, using the appropriate device code and source button for each source. [. . . ] See "Selecting the TV input" on page 16. · Check the connections from the Interface module to the TV or other source. · Check that the TV's audio output is enabled. See your TV owner's guide for information. [. . . ]