User manual BOSS 625CA

[. . . ] BUTTONS LOCATION AND FUNCTIONS MP3 MENU BUTTON 1 8 11 AUTOMATICALLY STORE / PRESET SCAN BUTTON 3 CD EJECT BUTTON PANEL MONO/ RELEASE STEREO BUTTON BUTTON VOLUME KNOB AUDIO BUTTON MUTE BUTTON PRESET MEMORY BUTTONS (M1~M6) SCAN BUTTON 10 4 2 7 9 12 POWER BUTTON 6 LO C A L / DISTANT BUTTON 15 REMOTE CONTROL RECEIVER 17 PRESET EQUALIZER BUTTON BAND/ LOUDNESS BUTTON DISPLAY BUTTON SOURCE BUTTON TUNING UP / DOWN TRACK UP / DOWN BUTTONS FOLDER DOWN /UP BUTTONS AUX IN JACK 13 MP3 ENTER BUTTON 5 ID3 TAG INFORMATION BUTTON 16 14 18 19 1 2. HANDLING COMPACT DISCS MOISTURE CONDENSATION On a rainy day or in a very damp area, moisture may condense on the lenses inside the unit. Should this occur, the unit will not operate properly. In such a case, remove the disc and wait for about an hour until the moisture has evaporated. NOTES ON CDs 1. [. . . ] Clock Adjustment Under clock display mode, press DISP button until the LCD flashes, press Tuning Up Button to adjust hour and Tuning Down Button to adjust minute. 16) SOURCE BUTTON (SOURCE) Press this button to select Radio and CD modes. The available selections depends on version: Radio CD Player Radio > CD 19) FRONT AUXILIARY INPUT JACK Connect the external signal to AUX in jack located at the front of the panel , then press SOURCE button to select Aux mode. Press SOURCE button again to cancel Aux mode and return to previous mode. AUX IN JACK IN PANEL 1 2 3 Left Audi o Right Audi o Gr ound 3. 5mm Audi o In Cabl e (not in cluded) RESET BUTTON The RESET button is located on the main unit (as shown on the diagram). To press it vertically with a ballpoint pen or metal object will activate it. The reset button is to be activated for the following reasons: Initial installation of the unit when all wiring is completed. All the function buttons do not operate. Note: If the unit cannot function normally after reseting, please use a cotton swab soaked in isopropyl alcohol to clean the socket on the back of the control panel. 7 7. AUDIO OPERATIONS 10) VOLUME KNOB Turn this knob to adjust desired volume level. 4) AUDIO BUTTON Press this button to select desired audio function. ORDER OF FUNCTION: VOLUME(VOL) -> BASS(BAS) -> TREBLE(TRE) ->BALANCE(BAL) ->FADER(FAD) While the selected function is displayed, turn Volume Knob to adjust the level within 5 seconds, otherwise the unit will return to volume adjustment mode. BEEPS 2ND, BEEP ALL , BEEP OFF Press and hold SELECT button to determine how the beep sound is generated when the keys are pressed, using V-UP/V-DN to select the desires settings: BEEP 2ND Beeps only when the second function of the dual function button is selected (long press). BEEP ALL Beeps when any buttons is pressed. BEEP OFF To disable the beep option. 2) MUTE BUTTON (MUTE) Press this button to mute the sound. 17) PRESET EQUALIZER BUTTON (EQ) Press this button to toggle the following EQ settings: FLAT->CLASSICS->POP M->ROCK M->DSP OFF At DSP OFF mode, EQ will be controlled by Bass/Treble setting. 13) BAND/LOUDNESS BUTTON (BAND/LOUD) Press the Band/Loudness Button for couple of seconds to switch the loudness on or off. When Loudness is on, display will show 'Loud On' for a few seconds. 8 8. RADIO OPERATIONS 11) AUTO MEMORY STORE/PRESET SCAN BUTTON (AS/PS) 1. PRESET SCAN: Press AS/PS button briefly to enter Preset Scan mode, it will scan all the preset stations in the memories, you can hear that it will stay on each station for about 5 seconds. AUTO MEMORY STORE: Press AS/PS button for couple of seconds to enter Auto Store mode, this feature will automatically scan the current band and enter up to 6 strongest stations into the 6 preset memories. To stop Auto Store & Scan, press the AS/PS button again. Press these buttons briefly to recall the stored stations in the selected band. Presetting stations manually, Press the BAND button to select the band for the stations to be preset. Use Tuning Up/Down to tune in the stations to be preset. [. . . ] In a multi-level directories disc, the movement will take place at the current level until the last directory is reached. At this point press directory down (M5) again , it will move to the next level of directory. ID3 TAG Press DISPLAY button repeatedly to Display ID3 TAG information. If the MP3 file is available with ID3 TAG, pressing the display button repeatedly will show information in the following sequence: SONG TITLE > ARTIST> ALBUM TITLE If any of the ID3-TAG information is not available, pressing the DISPLAY button repeatedly will show information in the following sequence: UNKNOWN SONGNAME> UNKNOWN ARTIST> NO ALBUM TITLE If the MP3 file is without ID3 TAG, pressing the DISPLAY button, & "NO ID3 TAG" will be displayed. The file name & track number of the MP3 file will scroll repeatedly through the display during the playing of the MP3 file. 12 11. REMOTE CONTROL 1 3 4 5 6 7 8 9 10 OPERATIONS: Key 1. [. . . ]