User manual BOSS BV7.3FLIP-BV7.3IRF-BV8FL-BV8WFLIP-BV8IRF

[. . . ] Thank you for making your choice for car video entertainment! 10 11 11 12 12 13 14 Remote control battery replacement Troubleshooting Specifications BV7. 3FLIP · BV7. 31RF · BV8FL · BV8WFLIP · BV8IRF User's Manual - Contents BV7. 3FLIP · BV7. 31RF · BV8FL · BV8WFLIP · BV8IRF User's Manual General precautions Please read this manual completely and carefully prior to attempting to install your new mobile video equipment. Installed correctly, your equipment will provide you with years of enjoyable and safe usage. Installation of this equipment in any portion of a vehicle which impairs or distracts the driver is improper and dangerous. [. . . ] Do not install components in areas which are susceptible to rain, moisture, direct sunlight, extreme heat or cold, excessive dust, dirt or humidity. If installation requires drilling holes or other modifications to the vehicle, consult with your nearest dealer or professional car audio installer. Use only the installation parts and hardware provided with the unit to ensure proper installation. Using other parts can cause malfunction and possible damage to your video monitor. Use only a power source with 12 Volts DC (negative ground). Before final installation, temporarily connect the wiring according to the diagram near the end of this manual, check it to ensure that it has been connected properly, and test the unit to make sure it is working correctly. After the monitor is installed, do not arbitrarily pull it down or strike it. This may loosen the mounting screws and cause it to fall down. Operating precautions Turn the unit off when it is not in use. Avoid dropping any metal objects or inflammable items into the monitor ventilation slots. Do not place objects on or suspend objects from the power cord, as this may damage the cord. BV7. 3FLIP · BV7. 31RF · BV8FL · BV8WFLIP · BV8IRF User's Manual - page 2 Features Your new video monitor features the following: · TFT Active Matrix LCD display · Swivel bracket permitting 30º rotation in left/right direction · Overhead console mounting bracket · On-screen menu system What is included? When first unpacking your new flipdown monitor, please check first that the package contains all of the items below. If something is missing, contact the store where you purchased the player. · LCD monitor housing · Wireless remote control with batteries · RCA-RCA video cable · Audio/video input controls · Power cable · Built-in dome lights · Wireless remote control Models BV7. 3IRF and BV8IRF also feature: · Built-in wireless infrared audio transmitter (for use with infrared headphones, model HP-10) (BV7. 3FLIP, BV8FL and BV8WFLIP) (red/black with inline fuse and 2-pin connector) -or- · Power/AV cable (BV. 3IRF and BV8IRF) (red/black with inline fuse and 2-pin connector, plus stereo RCA audio/RCA video inputs for each of two channels)) · Dome light cable (blue/red/white/black with 4-pin connector) · Metal mounting plate · (4) black 1/2" sheet metal screws (for attaching mounting plate to car roof) · (4) silver 1" machine screws (for attaching monitor to mounting plate) BV7. 3FLIP · BV7. 31RF · BV8FL · BV8WFLIP · BV8IRF User's Manual - page 3 Monitor Controls and Features: BV7. 3FLIP· BV7 IRF · BV8WFLIP · BV8IRF 1 2 3 4 5 1 REMOTE IR SENSOR 2 POWER ON/OFF This button turns the monitor system on and off. 4 MENU This button enables the on-screen display menu system. Once enabled, this button is used as an ENTER button. 5 UP/DOWN BUTTONS 3 A/V SOURCE SELECTOR Use this button to switch between A/V Source 1 and A/V Source 2. These buttons are used to increase or decrease parameters in the onscreen display menu system. BV7. 3FLIP · BV7. 31RF · BV8FL · BV8WFLIP · BV8IRF User's Manual - page 4 Monitor Controls and Features: BV8FL 1 POWER 2 A/V SOURCE 3 MENU 4 + 5 BV8FL 1 REMOTE IR SENSOR 2 POWER ON/OFF This button turns the monitor system on and off. 4 MENU This button enables the on-screen display menu system. [. . . ] Move to another area with better reception, if possible. Remote control does not function properly. Batteries are dead. Remote is not being used in direct line-of-sight with the player or remote IR sensor. Transmission is best within 6 feet/30º angle of IR sensor on monitor front panel, and within . Replace batteries. [. . . ]