User manual BOSS BV8855T

[. . . ] BV8855T Contents Precautions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Safety Information. . . . . . . . . . . . . . . . . . . . . . . . . 3 Disc Notes . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Adjust sound balance between left and right speakers by using VOL + / - . Adjust sound balance between front and rear speakers by using VOL + / VOL - . The RESET button is to be activated for the following reasons: A. Initial installation of the unit when all wiring is completed. All the function buttons do not operate. Error symbol on the display. Setting Audio Modes Touch the screen the DSP range (or press the EQ button on the remote control ) to select one of the preset sound modes . The information will display in the monitor as follow : DSP USA/EURO FREQUENCY SWITCH On the right of this device, there is a USA/EURO frequency switch, you can select the desired radio frequency before installing . POP FLAT FLAT ROCK JAZZ CLASSIC 16: 18 DISC-IN POP USA/EURO Frequency Switch (radio frequency switch for selecting between the USA and EUROPE frequency band. ) S-WOOFER OSD TA DSP AF CLK LUD GOTO touch to select It`s depend on your habit to select the Audio mode . Reset Factory Settings RESET button is placed on the housing and must be activated with either a ballpoint pen or thin metal object. RES RESET -18- Radio Operation Listening to the Radio Switching To Radio Mode Touch the screen of "MODE" range (or press the MOD button on the front panel ) repeatedly to select the RADIO mode. the following information will appears as below: MODE Start Searching For a Station Manual Search During Radio mode, briefly touch the screen of " " section or press the " " on front panel to increase frequency by one step of channel spacing . Briefly touch the " " section or press the " " button on the front panel to decrease frequency by one step of channel spacing . FLAT ST 12:06 NO-DISC DX Automatic Search During Radio mode, touch and hold (for more than 2's ) the screen of " / " section or press longer the " / " on the front panel to start search for a radio station automatically . FM1 MODE 1 2 3 SEL 87. 60 MHZ MUTE ON 4 5 6 VOLUME- VOLUME+ FLAT ST 12:06 NO-DISC AF DX When an FM stereo broadcast is hard to receive Touch the "STEREO/MONO" section on touch screen (or press ST/MO button on the remote control ) to select the MONO or STEREO mode . (When Stereo mode is activated, the ST symbol will appear . ) FM1 BND TA PTY AF CLK 87. 60 MHZ S-WOOFER LUD APS LOC/DX DSP STEREO/MONO Touch " Touch " " to next . " to previous . To tune in strong-singnal FM Station only (LO/DX function) Touch the " LOC/DX " range on the touch screen (or press LO/DX button on the remote control ) to select the LOCAL or DX mode . ( You can choose between the LOCAL and DX(DISTANCE) mode for local or long-distance traffic news . ) Selecting The Frequency Band BND Touch the screen of " BND " section (or press the BND on the front panel ) repeatedly to select the band , the message will show in turn : FM1 FM2 FM3 AM1(MW1) -19- AM2(MW2) Radio Operation Storing Stations In Memory Setting Memory Press the " / CH 1-6 " button repeatedly on the front panel to preset stations at radio mode . ( Or touch the screen the 1-6 sections ) FLAT ST 12:06 NO-DISC DX automatic station storage. The radio searches within the current frequency band, e. g. FM1, for the stronger signal level until the search cycle has finished . The six strongest stations are then allocated to the corresponding storage locations . Then the station of the first storage location is set . FM1 MODE 1 2 3 SEL 87. 60 MHZ MUTE ON 4 5 6 Scan Function In Radio mode, briefly touch the APS section on the touch screen , the radio briefly plays all the preset stations of the frequency band . APS VOLUME- VOLUME+ Touch to preset station With this system, a total of 30 stations can be stored in the memory of six buttons. Each band stores up to six preset stations. The stations might be FM1, FM2, FM3, AM1(MW1), and AM2(MW2) band. [. . . ] Inserting the SD or MMC card . Label side facing backward Insert the memory card into slot with label side facing backward . Removing the SD or MMC card . Press in till heard a "CLICK" . Press in till heard a "CLICK" . Remove the memory card . Mode change to SD/MMC card After a SD or MMC card was inserted into the main unit card slot . The unit will starts playing the files contained on the memory card . Once the unit read the memory card successfully, the first file on the memory card will automatically start play back . [. . . ]