User manual BOSS CHAOS SE800

[. . . ] Insert the compact disc with the label facing upward. Clean the disc or try to play a new one. Cool off or until the ambient temperature returns to normal. Leave the player off for an hour or so, then try again. [. . . ] Install the unit where it does not get in the driver's way and cannot injure the passenger if there is a sudden stop, like an emergency stop. If installation angle exceeds 30 from horizontal, the unit might not give its optimum performance. 30 Avoid installing the unit where it would be subject to high temperature, such as from direct sunlight, or from hot air, from heater, or where it would be subject to dust dirt or excessive vibration. Be sure to remove the front panel before installing the unit. DIN FRONT/REAR-MOUNT BAND NAME AMERICAN 1 AMERICAN 2 EUROPE 10 EUROPE 5 MID EAST AUST (AUSTRALIA) RUSSIA JAPAN FREQUENCYRANGE FM:87. 5-108MHz FM:87. 5-107. 9MHz FM:87. 5-108MHz FM:87. 5-108MHz FM:87. 5-108MHz FM:87. 5-108MHz FM:65. 0-74MHz FM:76. 0-90. 0MHz AM:530-1710kHz AM:530-1710kHz AM:522-1620kHz AM:522-1620kHz AM:531-1602kHz AM:522-1593kHz AM:522-1620kHz AM:522-1629kHz This unit can be property installed either from Front (conventional DIN Front-mount) or Rear (DIN Rear-mount installation, utilizing threaded screw holes at the sides of the unit chassis). For details, refer to the following illustrated installation methods A and B. DIN FRONT-MOUNT (Method A) Installation the unit 1 182 2 53 To change the range to suit your location, press DOWN ARROW until the desired frequency range is hight lighted. The press > to save it and move to next setting area. -AUX Input Enable/Disable Press DOWN ARROW to move between Enable and Disable modes. When the selection has been made, press> to save it and move to next setting area or press ENTER to leave the System Setting mode. If Aux Input is disable in System Settings, anyinput connected will not be played. 3 1. Holder After inserting the half sleeve into the dashboard, select the appropriate tab according to the thickness of the dashboard material and bend them inwards to secure the holder in place. Screw 1 5 3 -Clock Format (12-hour or 24-hour) Press DOWN ARROW to move between 12-hour and 24-hour format, press > to save it and move to next setting area or press ENTER to leave the System Setting mode. 1. 5. 2 4 Dashboard Nut (5mm) Screw (5x15mm) Screw Support Strap Be sure to use the support strap to secure the back of the unit in place. 1. ) I<< and >>I (Skip back/skip forward, fast back/fast forward) Press those buttons to skip back or ahead one track. Press and hold for fast back or fast forward. 4 2. ) RDM (Random Play Mode) Press this button to play all MP3 files in random order. Press again to cancel. 3 7 5 9 1 2 1. ) VOLUME UP/DOWN KNOB (TURN) AUDIO MODE SELECTOR (PRESS) In normal mode, use this knob to increase / decrease the volume level. To access various sound parameters push the button (like a button) to cycle through the following adjustable settings: VOLUME>BASS>TREBLE>BALANCE >FADER>EQUALIZER Use volume knob to increase / decrease the setting of Volume, Bass, Treble, Balance and Fader For Equalizer, rotate the volume knob cycle through and select response curve you wish: FLAT, POPS, ROCK or CLASSIC. To save setting, press the knob and move on next parameter. You can exit the system by pressing until you return to VOL, or simply do nothing and the unit will return to normal mode automatically. 2. ) POWER Press Power to turn on the unit. Press and hold Power to turn off the unit. 3. ) MODE Press the button repeatly to cycle through the audio input sources: RADIO>CD>USB>SD CARD>AUX IN 4. ) AUX IN This jack is a convienent way to play music from MP3 player such as iPod throguh your car stereo. Simply connect headphone output from MP3 player to this input jack. Press MODE to select AUX as input source and begin to play music on the MP3 player. [. . . ] Press PLAY to begin playback on the first track (NOT the track on last play) 3. ) PAUSE Press to pause playback. Press PLAY to resume playback from last play 4. ) SCAN (Intro Scan) To audition the first 10 seconds each track, press this button. Press again to cancel and begin to play the auditioned track. 5. ) REPEAT (Repeat Play Mode) Press this button to repeat all the playback automatically. [. . . ]