User manual BOSS CHAOS WIRED CW2000M

[. . . ] Check wiring connection. DIN FRONT/REAR-MOUNT This unit can be property installed either from Front (conventional DIN Front-mount) or Rear (DIN Rear-mount installation, utilizing threaded screw holes at the sides of the unit chassis). For details, refer to the following illustrated installation methods A and B. DIN FRONT-MOUNT (Method A) Installation the unit Insert the antenna cable firmly. Replace with a good sensitivity whip antenna 1 182 2 53 3 1. [. . . ] - Radio Settings The unit can operate on serveral different frequency ranges. Please see the following for these ranges. The default frequency range is AMERICAN 2 . BAND NAME FREQUENCY RANGE Removing the unit a a . Insert the levers supplied with the unit into the grooves at both sides of the unit as shown in figure until they click. Pulling the levers makes it possible to remove the unit from the dashboard. AMERICAN 1 AMERICAN 2 EUROPE 10 EUROPE 5 MID EAST AUST (AUSTRALIA) RUSSIA JAPAN FM:87. 5-108MHz FM:87. 5-107. 9MHz FM:87. 5-108MHz FM:87. 5-108MHz FM:87. 5-108MHz FM:87. 5-108MHz FM:87. 5-108MHz FM:87. 5-108MHz AM:520-1710kHz AM:530-1710kHz AM:522-1620kHz AM:522-1620kHz AM:531-1602kHz AM:522-1593kHz AM:522-1620kHz AM:522-1629kHz To change the range to suit your location, press DOWN ARROW until the desired frequency range is hightlighted. The press > to save it and move to next setting area. -AUX Input Enable/Disable Press DOWN ARROW to move between Enable and Disable modes. When the selection has been made, press > to save it and move to next setting area or press ENTER to leave the System Setting mode. If Aux Input is disable in System Settings, any input connected will not be played. -Clock Format (12-hour or 24-hour) Press DOWN ARROW to move between 12-hour and 24-hour format, press > to save it and move to next setting area or press ENTER to leave the System Setting mode. - 10 - -3- General And Radio Control 2 1 6 4 Specifications Supply voltage Current consumption Audio signal output Characteristics Frequency coverage : 12V DC(11V-15V) : Less than 15A : 2 CH line out : Frequency response: 100Hz 10KHz : AM 530 - 1710KHz ; FM 87. 5 - 107. 9MHz 3 7 8 5 1. ) VOLUME UP/DOWN KNOB (TURN) AUDIO MODE SELECTOR (PRESS) In normal mode, use this knob to increase / decrease the volume level. To access various sound parameters push the button (like a button) to cycle through the following adjustable settings: VOLUME>BASS>TREBLE>BALANCE >FADER>EQUALIZER Use volume knob to increase / decrease the setting of Volume, Bass, Treble, Balance and Fader For Equalizer, rotate the volume knob cycle through and select response curve you wish: POPS, ROCK , CLASSIC or FLAT. To save setting, press the knob and move on next parameter. 5. ) VOLUME - / VOLUME + Use to increase or decrease volume level 6. ) LOC (Local/Distant Select)In some areas, the reception of FM stations may be weak. Change the reception mode to LOC by pressing the button may improve the reception. 7. ) SELECT Press this button to cycle through the following adjustable settings: VOLUME>BASS>TREBLE>BALANCE >FADER>EQUALIZER 8. ) MO/ST In some areas, the reception of FM stations may be weak. Change the reception mode to MONO by pressing the button may improve the reception. Press again to return to STEREO 9. ) RADIO PRESET 1-6 After you preset the stations via front panel, you can use this buttons 1-6 to select the preset stations. 10. ) AMS (Auto Music Scan) This is the easiest way to set up the preset station in each radio band. If you press AMS, the radio will scan up all the strongest station and preset automatically. Please note, all the previous preset will be lost. 11. ) Loudness Press to increase bass output. Press again to turn off Loudness function. 9 10 12 11 13 12. )BAND Press briefly, repeatly to cycle through five radio bands: FM1>FM2>FM3>AM1>AM2 13. ) SOURCE (Input select, same as MODE on head unit) Press the button repeatly to cycle through the audio input sources: RADIO>USB>SD CARD > AUX IN -8- -5- USB/SD Card (M P3 Playback) Control using remote control. . . . 1. ) I<< and >>I (Skip back / forward) Press those buttons to skip back or ahead one track. [. . . ] For example, #45, press 4, 5, Enter and the 45th track will begin to play. 7. ) SOURCE (Input select, same as MODE on head unit) Press the button repeatedly to cycle through the 4 audio input sources in order to select either USB or SD modes. 6 4 5 1 2 7 1 2 3 4 5 6 8 9 3 1. ) DIRECT SEARCH The MP3 playback in USB / SD Card contain Direct Search function. You can press and hold VOL knob until DIRSEARCH . Rotate the knob to select specific track folder. [. . . ]