User manual BOSS MP3-3130R

[. . . ] Insert and tighten the "headless" support screw into the back of the head unit where shown. Insert the mounting case for the head unit into the dashboard. Inspect the dashboard material to determine its approximate thickness. Select the appropriate support tabs and bend them outward to secure the bracket in place (Figure 1). [. . . ] Play will begin at the point when you release the button. TO PLAY A CD gently insert a CD with the label side up into the disc slot. It will automatically load and begin playing the first track. TO EJECT A CD press EJECT to stop the CD playback and eject the CD from the slot. The receiver will automatically switch to radio mode. TO PAUSE A CD press PAUSE to stop playback temporarily. TO SKIP TRACKS press the I<< or >>I key to choose the next or preceding track. TO FAST FORWARD OR REVERSE press and hold the I<< or >>I key to the desired location on the disc. Releasing the button starts playback at the location. TO REPEAT A TRACK press REPEAT to continuously repeat the current track. Press again to return to normal playback mode. TO PREVIEW ALL TRACKS press CD SCAN to play the first several seconds of each track. Press it again to stop an play the current track being previewed. TO PLAY TRACKS IN RANDOM ORDER press SHUF several seconds. Press again to cancel this function. 2 PAUSE Press to pause CD playback. Press again to resume playback. 3 CD SCAN Press to hear first several seconds of each track on current disc. Press again to stop intro and listen to intro last previewed. 4 REPEAT Press and release to continuously repeat same track. Press again to stop repeat cycle. 5 SHUFFLE Press to play ALL tracks on the CD in random order. 6 EJECT Press to eject CD. CD3125R/MP3-3130R User's Manual - page 8 Controls behind faceplate 1 RELEASE 3 2 1 CD LOADING/UNLOADING SLOT 2 LED This LED flashes when the faceplate is removed. 3 RESET BUTTON Press this button with a ballpoint pen or other thin object. Use it: a) after initial installation of the unit, when all wiring is complete b) when the function buttons do not operate c) when the display is shows "ERROR" NOTE: If the unit does not function properly after you have pressed the RESET button, clean the socket and the connector on the rear of the front panel with a cotton swab soaked in isopropyl alcohol and try again. CD3125R/MP3-3130R User's Manual - page 9 MP3 Playback (MP3-3130R only) Since MP3 files are named and accessed differently than CD files, it is necessary to employ some of the buttons for purposes of searching for and selecting audio files. The AS/PS button is used to select the search mode by pressing it once or twice. SEARCH TRACK DIRECTORY MODE Pressing the AS/PS button once enters the Searching Track Directory mode. To enter a track number, use the buttons according to the chart below: Front panel control Preset 1 Preset 2 Preset 3 Preset 4 Preset 5 Preset 6 Source I<< >>I DISP Key assignment 1 2 3 4 5 6 7 8 9 0 SEARCH FILE NAME MODE Pressing the AS/PS button twice enters the Searching File Name mode. [. . . ] Front panel is not properly fixed in place. Adjust volume to desired level. Check wiring connections. Adjust installation angle to less than 30º from horizontal. Press the RESET button. Remove front panel, press RESET button, and re-insert front panel. Insert the antenna cable firmly into connector. [. . . ]