User manual BOSS MP3-3195R

[. . . ] BUTTONS LOCATION AND FUNCTIONING 1 PANEL RELEASE BUTTON 12 POWER BUTTON (ILL) 3 LOCAL/DX BUTTON (LOC) 17 PRESET EQUALIZER BUTTON 4 PANEL OPEN/EJECT BUTTON ENCODER VOLUME BUTTON MUTE AUDIO BUTTON BUTTON PRESET MEMORY BUTTONS (M1~M6) BAND/LOUDNESS BUTTON 10 ID3 TAG INFORMATION BUTTON 5 2 7 13 MP3 ENTER BUTTON 8 6 DISPLAY BUTTON MONO/ STEREO BUTTON 15 REMOTE CONTROL RECEIVER SCAN BUTTON SOURCE BUTTON / SUB-WOOFER AUTOMATICALLY TUNING UP / DOWN STORE / PRESET TRACK UP / DOWN SCAN BUTTON BUTTONS FOLDER DOWN /UP BUTTONS 9 16 11 14 18 MP3 MENU BUTTON E-1 2. HANDLING COMPACT DISCS MOISTURE CONDENSATION On a rainy day or in a very damp area, moisture may condense on the lenses inside the unit. Should this occur, the unit will not operate properly. In such a case, remove the disc and wait for about an hour until the moisture has evaporated. NOTES ON CDs 1. [. . . ] This may cause serious & permanent damage to the unit & panel. Only attach or detach the front panel when the panel is in the slide up position. E-7 7. BASIC OPERATIONS 1) PANEL RELEASE BUTTON (REL) Press this button to remove the control panel. 12)POWER ON/OFF BUTTON Press this button long to turn on or off the power. In VFD button short press this button to toggle dimmer function. This will change the brightness of VFD and there are three levels of brightness can be selected. 6) DISPLAY BUTTON (DISP) Press this button briefly, the VFD will display the clock for about 2 seconds, then return to previous display mode. Clock Adjustment Under clock display mode, press DISP button until the VFD flashes, press Tuning Up Button to adjust hour and Tuning Down Button to adjust minute. 16) SOURCE BUTTON (SOURCE) Press this button to select Radio , CDP or AUX modes. The available selections depends on version: Radio CD Player Radio > CDP > AUX in Sub-woofer On/Off Press SOURCE button for more than 3 seconds to activate or turn off the Sub-woofer output. Aux Input Connect the external signal to the auxiliary line in jack located at the rear of the unit , then press Source button to select Aux mode. Press Source Button again to cancel Aux Mode and return to previous mode. RESET BUTTON The RESET button is located on the main unit (as shown on the diagram). To press it vertically with a ballpoint pen or metal object will activate it. The reset button is to be activated for the following reasons: RE SE T Initial installation of the unit when all wiring is completed. All the function buttons do not operate. Note: If the unit cannot function normally after reseting, please use a cotton swab soaked in isopropyl alcohol to clean the socket on the back of the control panel. E-8 8. AUDIO OPERATIONS 10)ENCODER VOLUME BUTTON Turn this knob to adjust desired volume level. 5) AUDIO BUTTON Press this button to select desired audio function. ORDER OF FUNCTION: VOLUME(VOL) -> BASS(BAS) -> TREBLE(TRE) ->BALANCE(BAL) ->FADER(FAD) While the selected function is displayed, turn Volume Knob to adjust the level within 5 seconds, otherwise the unit will return to volume adjustment mode. 2) MUTE BUTTON (MUTE) Press this button to mute the sound. 2. Press these buttons for more than 2 seconds, operate as MANUAL SEARCH buttons, under this mode the tuning frequency will advance up or down rapidly when the button is pressed. If the buttons are not pressed within 3 seconds, they will return to auto search mode. 3) LOCAL/DISTANT BUTTON (LOC) During station tuning, this button allows you prior to access strong local station only (Local mode), or to access a wider range of using distant mode (DX). [. . . ] The file name & track number of the MP3 file will scroll repeatedly through the display during the playing of the MP3 file. E - 13 12. REMOTE CONTROL 1 2 3 4 5 6 7 8 9 10 11 12 13 14 OPERATIONS: Key 1. ID3/DISP Radio Mode Power On/Off CD Player Mode Power On/Off MP3 Mode Power On/Off Adjust Vol, Bas, Tre, Fad, Bal Display Clock Adjust Vol, Bas, Tre, Fad, Bal Display Clock Adjust Vol, Bas, Tre, Fad, Bal ID3 Tag information Display Clock, Numeric key 0* 4. Stereo/Mono Stereo/FM Mono Tuning/Seek Up/Down Local/Distant Station Scan Mute Select Vol, Bas, Tre, Fad, Bal No Function Track Up/Down No Function No Function Mute Select Vol, Bas, Tre, Fad, Bal No Function Track Up/Down/ Numeric key 8*9* No Function No Function Mute Select Vol, Bas, Tre, Fad, Bal, 5. Band/Loud/ Enter Sub-woofer/ Change to CD/MP3 or AUX IN Band/Loudness Auto Store/Preset Scan Preset EQ Preset station 1 Preset station 2 Preset station 3 Preset station 4 Preset station 5 Preset station 6 Sub-woofer/ Change to Radio or AUX IN Sub-woofer/ Change to Radio or AUX IN / Numeric key 7* Loudness No function Preset EQ Pause CD scan Repeat Shuffle No Function No Function Loudness/ MP3 Enter Menu function Preset EQ 12. Numeric Key(1) (2) (3) (4) (5) (6) Pause CD scan Repeat Shuffle Folder Down Folder Up E - 14 13. SPECIFICATIONS CD PLAYER System Usable disc Sampling frequency No of quantization bits Frequency Number of channels S/N Ratio Compact disc audio system Compact disc 44. 1KHz 1bit 5-20, 000Hz 2 stereo 70dB RADIO SECTION FM Frequency Range Intermediate Frequency Usable Sensitivity Stereo Separation S/N Ratio 87. 5-107. 9MHz 87. 5-108MHz 10. 7 MHz Better than 15dB at S/N 30 dB 25 dB at 1KHz 50 dB 530-1710KHz 522-1620KHz 450KHz Better than 45dB 40 dB AM/MW Frequency Range Intermediate Frequency Usable Sensitivity S/N Ratio GENERAL Power Supply Polarity Speaker impedance Power Output DC 11 -14V Negative Ground 4 ohms 4x 70 Watts REMARK : Specifications subject to change without notice. E - 15 14. TROUBLE SHOOTING Before going through the check list, check wiring connection. [. . . ]