User manual BOSS MR-1200

[. . . ] We are sure you'll enjoy listening to your favorite music with this 33bE component as part of your car audio system. For best DIN Front-Mount (Method A) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Installing the unit . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Removing the unit . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Install the unit where it does not get in the driver's way and cannot injure, the passenger if there is a sudden stop, like an emergency stop. If installation angle exceeds 30efrom horizontal, the unit might not give its optimum performance. DIN FRONT-MOUNT (Method A) Installing the unit ! Removing the unit Fastening the unit to the factory radio mounting bracket. Select a position where the screw holes of the bracket and the screw holes of the main unit become aligned (are fitted), and tighten the screws at 2 places on each side. Use either truss screws (5 x 5mm) or flush surface screw (4 x 5mm), depending on the shape of the screw holes in the bracket. Hook (Removethis part) Note: The mounting box, outer trim ring, and half-sleeve are not used for method B installation. 1. Mounting Bracket After inserting the mounting bracket holder into the dashboard, select the appropriate tab according of the dashboard material and bend them inwards to secure the mounting bracket holder in place. Insert fingers into the groove in the front of frame and pull out to remove the frame. (When reattaching the frame, point the side with a groove downwards and attach it. ) 3. Lever Insert the levers supplied with the unit into the grooves at both sides of the unit as shown in figure until they click. Pulling the levers makes it possible to remove the unit from the dashboard. DIN REAR-MOUNT (Method B) Installation using the screw holes on the sides of the unit. Avoid installing the unit where it would be subject to high temperature, such as from direct sunlight, or from hot air, from the heater, or where it would be subject to dust, dirt or excessive vibration. DIN FRONTIREAR-MOUNT This unit can be properly installed either from "Front" (conventional DIN Frontmount) or '. 'Rearw (DIN Rear-mqunt installation, utilizing threaded screw holes at the sides of the unit chassis). For details, refer to the following illustrated installation methods. 1. 5. Dashboard Nut (5mm) Spring washer Screw (5 x 25mm) Screw 6. Strap Be sure to use the strap to secure the back of the unit in place. [. . . ] For 2-speakers system, green, violet, white/black and grey/black wire leads are unconnected and isolated. For 2-speakers system, keep the fader indicator at center position to maintain the existing volume level. Front Panel "nto the 4. A 'click' souoOd shouldh heard. 6. [. . . ]