User manual BOSS MR120

[. . . ] Use only the installation parts and hardware provided with the unit to ensure proper installation. Using other parts can cause malfunction and possible damage to your CD receiver. Do not install this unit at an angle in excess of 30º from horizontal, as it may affect performance. Although this unit has been designed for outdoor use, you can extend its life if you install it in a location which is not subject to extreme temperatures, from such sources as heaters or exhaust lines. [. . . ] Press again to turn it off. 2 TUNE/TRACK BUTTONS In Radio mode, press these buttons briefly to step up or down the radio dial in single step increments. Press and hold for more than one-half second and the tuner will enter the SEEK mode. In this mode the tuner will stop at the next strong station available. In CD mode, pressing these buttons briefly will advance the player to the next (or previous) track. Press and hold and the player will enter SEARCH mode. 6 MODE (Input Select) Press this button repeatedly to cycle through the audio input sources in the following order: RADIO > CD > AUX > AUX 1 (front panel aux input) To clear all stored memories, press and hold this button for several seconds. 3 PLAY/PAUSE, MUTE Discs will begin playback automatically upon insertion. Press and hold this button to silence the audio. Press again to restore the previous audio volume level. MR120 User's Manual - page 10 7 SELECT The SELECT button is used to access a wide range of settings for the receiver. · Clock time: If the frequency area switches from American to European, the clock will display 24:00. Similarly if the area switches from European to American, the clock will display 12:00. Use the UP/DOWN buttons to adjust the minutes or hours. · Subwoofer channel: ON/OFF · LOC/DX radio reception: LOC/DX · Area: Factory set to the country in which the radio is sold. For information on assigning using the PTY function, please see page 16 of this manual. 15 AS/PS (Automatic preset setup, preset scan function) When pressed and held for several seconds, the tuner will search and store the first six strong stations as presets in the current radio band. Press this button briefly, repeatedly to step between and listen to the six presets of the current band. 18 RESET If you experience abnormal functioning of the unit, try turning the unit off and back on again about ten minutes later. If problems persist, remove and carefully reinsert the front panel, making sure it is fully seated. If problems continue, remove the panel again and clean the connector on the back of the panel with a cotton swab moistened with isopropyl (rubbing) alcohol. If you still have problems, press the reset button with a small pointed object such as a ball point pen. This will restore all factory defaults to the unit, which includes clearing your radio presets. RESET button 18 MR120 User's Manual - page 13 Remote Control 1 POWER Use to turn CD Receiver ON or OFF. 2 MODE Press to choose desired audio source: RADIO > CD > AUX1 IN > AUX (front panel aux input) 3 BAND Press briefly, repeatedly to cycle between the radio bands: 1 FM1 > FM2 > FM3 > AM1 > AM2 > WB (Weather Band) MODE TUNE · TRACK BAND 3 MUTE 2 SCAN 4 4 SCAN/EON ON/OFF In Radio Mode, when you press this button briefly the tuner will scan up the band until it detects a strong station. Then it will stop, and the frequency of that station will be displayed in a flashing pattern for about 5 seconds. If you wish to hear this station, press SCAN again. If you do not push SCAN, the tuner will scan up to the next station and repeat the same pattern. To turn on EON mode of RDS System, press and hold this button. When the EON function is turned on, "EON" will be displayed on the screen (for more information about the EON function see page 14). VOLUME MARINE REMOT E COMMANDER 5 6 7 8 6 PLAY/PAUSE Discs will begin playback automatically upon insertion. [. . . ] If at any time you wish to return to normal tuning mode, press and hold again. When you have entered PTY mode, the display will show "PTY" indicating that the mode is enabled, and the name of the first program type, "NEWS. " To view other PTY categories, use the UP/DOWN buttons (a list of these categories is shown on the next page). To select the category, highlight it and press SELECT. If there is no station found in that category, the display will show "NONE PTY" and the radio will return to normal mode. MR120 User's Manual - page 16 PTY Station Categories This list shows the PTY program types in the order presented in the radio display: Weather Band Tuning Weather band listening is available using TUNE/TRK buttons or the radio presets. [. . . ]