User manual BOSS MR1420W

[. . . ] BUTTONS LOCATION AND FUNCTIONS MP3 MENU BUTTON 1 8 11 AUTOMATICALLY STORE / PRESET SCAN BUTTON 3 CD EJECT BUTTON PANEL MONO/ RELEASE STEREO BUTTON BUTTON VOLUME KNOB AUDIO BUTTON MUTE BUTTON PRESET MEMORY BUTTONS (M1~M6) SCAN BUTTON 10 4 2 7 9 12 POWER BUTTON 6 LOCAL/ DISTANT BUTTON 16 PRESET EQUALIZER BUTTON BAND/ LOUDNESS BUTTON DISPLAY BUTTON SOURCE TUNING UP / DOWN TRACK UP / DOWN BUTTON / BUTTONS SUB-WOOFER FOLDER DOWN /UP BUTTONS AUX IN JACK 13 MP3 ENTER BUTTON 5 ID3 TAG INFORMATION BUTTON 15 14 17 18 1 2. HANDLING COMPACT DISCS MOISTURE CONDENSATION On a rainy day or in a very damp area, moisture may condense on the lenses inside the unit. Should this occur, the unit will not operate properly. In such a case, remove the disc and wait for about an hour until the moisture has evaporated. NOTES ON CDs 1. [. . . ] The available selections depends on version: Radio CD Player Radio > CD > AUX in Sub-woofer On/Off Press SOURCE button for more than 3 seconds to activate or turn off the Sub-woofer output. 18) FRONT (AND REAR PANEL) AUXILIARY INPUT JACKS This unit features AUX IN line input jacks on both the front (headphone type) and rear (RCA type) panels. PLEASE NOTE: AUX IN JACK IN PANEL These two inputs cannot be used simultaneously. If you have a source unit plugged into the rear panel jack and wish to listen to a portable device (such as an MP3 player) by using the front panel jack, be sure to power off the unit plugged into the rear unit to Left Audio avoid interference. Right Audio Ground Similarly, if you have a device plugged into the front panel jack and wish to listen to the unit plugged into 3. 5mm Audio In Cable (not included) the rear panel, be sure to turn off the front panel device. To select either the front or rear AUX IN device as a listening source, press the SOURCE button to select AUX mode. To cancel AUX IN listening, press SOURCE again. 1 2 3 RESET BUTTON The RESET button is located on the main unit (as shown on the diagram). To press it vertically with a ballpoint pen or metal object will activate it. The reset button is to be activated for the following reasons: RESET BUTTON The RESET button is located on the main unit (as shown on the diagram). To press it vertically with a ballpoint pen or metal object will activate it. The reset button is to be activated for the following reasons: Initial installation of the unit when all wiring is completed. All the function buttons do not operate. Note: If the unit cannot function normally after reseting, please use a cotton swab soaked in isopropyl alcohol to clean the socket on the back of the control panel. 7 7. AUDIO OPERATIONS 10) VOLUME KNOB Turn this knob to adjust desired volume level. 4) AUDIO BUTTON Press this button to select desired audio function. ORDER OF FUNCTION: VOLUME(VOL) -> BASS(BAS) -> TREBLE(TRE) ->BALANCE(BAL) ->FADER(FAD) While the selected function is displayed, turn Volume Knob to adjust the level within 5 seconds, otherwise the unit will return to volume adjustment mode. 2) MUTE BUTTON (MUTE) Press this button to mute the sound. 16) PRESET EQUALIZER BUTTON (EQ) Press this button to toggle the following EQ settings: FLAT->CLASSICS->POP M->ROCK M->DSP OFF At DSP OFF mode, EQ will be controlled by Bass/Treble setting. 13) BAND/LOUDNESS BUTTON (BAND/LOUD) Press the Band/Loudness Button for couple of seconds to switch the loudness on or off. When Loudness is on, display will show 'Loud On' for a few seconds. 8 8. RADIO OPERATIONS 11) AUTO MEMORY STORE/PRESET SCAN BUTTON (AS/PS) 1. PRESET SCAN: Press AS/PS button briefly to enter Preset Scan mode, it will scan all the preset stations in the memories, you can hear that it will stay on each station for about 5 seconds. AUTO MEMORY STORE: Press AS/PS button for couple of seconds to enter Auto Store mode, this feature will automatically scan the current band and enter up to 6 strongest stations into the 6 preset memories. [. . . ] Rotate VOLUME KNOB counter-clockwise first to navigate through the directory list, press MP3 ENTER BUTTON to select the desired directory. To select the tracks under the selected directory, by Rotating VOLUME KNOB counter-clockwise first, then press MP3 ENTER BUTTON to confirm when desired track is found. (D) NAVIGATING THROUGH DIRECTORY BY USING M5/M6 BUTTON Press directory up (M6) or directory down (M5) buttons to skip the current directory forward or backward by one position. In a multi-level directories disc, the movement will take place at the current level until the last directory is reached. At this point press directory down (M5) again , it will move to the next level of directory. ID3 TAG Press DISPLAY button repeatedly to Display ID3 TAG information. [. . . ]