User manual BOSS ONYX N1800.2

[. . . ] Dangerous high voltages are present which may result in electric shock. Refer any repairs to a qualified service technician. · Do not attempt to repair a damaged, broken or faulty power cord. Replace it with a new one immediately. SHOCK HAZARD! [. . . ] Replace it with a new one immediately. SHOCK HAZARD!There are dangerous voltages present within the unit. There are no user-serviceable parts within the unit. ONYX N1800. 2 User's Manual - page 2 Installation precautions Choose a mounting location in your vehicle where the unit will not distract or otherwise interfere with the driver's ability to control the vehicle. Do not install components in areas which are susceptible to rain, moisture, direct sunlight, extreme heat or cold, excessive dust, dirt or humidity. If installation requires drilling holes or other modifications to the vehicle, consult with your nearest dealer or professional car audio installer. Use only the installation parts and hardware provided with the unit to ensure proper installation. Using other parts can cause malfunction and possible damage to your new video monitor. Use only a power source with 12 Volts DC (negative ground). Before final installation, temporarily connect the wiring according to the diagram near the end of this manual, check it to ensure that it has been connected properly, and test the unit to make sure it is working correctly. After the monitor is installed, do not arbitrarily pull it down or strike it. Using the wires provided, complete the audio, video and power connections in your vehicle as shown in the diagram below. VIDEO SOURCE 1 VIDEO INPUT 1 (YELLOW) (DVD player, video game, etc. ) VIDEO OUTPUT VIDEO SOURCE 2 VIDEO INPUT 2 (YELLOW) (DVD player, video game, etc. ) VIDEO OUTPUT RED FUSE BLACK 12V Battery to Chassis Ground ONYX N1800. 2 User's Manual - page 6 On-screen (OSD) menu system This monitor incorporates an on-screen menu display systems which permits you to setup the monitor for a wide variety of installations and applications. Enter the OSD menu system by pressing the MENU BUTTON on the front of the monitor or on the remote control. The monitor will display a menu with the following functions, which you can adjust individually: BRIGHTNESS: Makes the image more or less bright CONTRAST: Increases or decreases the image intensity COLOR: Makes the colors more or less saturated TINT: Permits you to shift the color range, making it greener or redder. Note: Tint adjustment only available when monitor is in NTSC mode. RESET: Returns all settings to factor values EXIT: Allows you to exit the OSD system. The basic navigation method for this menu system is to: 1 - Press the MENU button to enter the OSD system. 2 - Press MENU to move to the desired setting you wish to adjust. 3 - Use the left and right arrows to change the setting. 4 - Press MENU to confirm the setting and move to other settings you wish to change. To exit the OSD system press the MENU button until you have highlighted EXIT and press MENU again. Display presets (Mode Button on Remote) This monitor features preset combinations of settings for Picture, Brightness, Color and Contrast (called Standard, Strong and Soft). You may prefer these to setting up your own using the OSD system. [. . . ] 4 - Press MENU to confirm the setting and move to other settings you wish to change. To exit the OSD system press the MENU button until you have highlighted EXIT and press MENU again. Display presets (Mode Button on Remote) This monitor features preset combinations of settings for Picture, Brightness, Color and Contrast (called Standard, Strong and Soft). You may prefer these to setting up your own using the OSD system. Press MODE on the remote control to access these presets. [. . . ]