User manual BOSS RDS-4600MP3

[. . . ] BUTTONS LOCATION AND FUNCTIONING TA BUTTON 1 PANEL RELEASE BUTTON 12 POWER BUTTON 3 LOCAL/DX BUTTON (LOC) 17 PRESET EQUALIZER BUTTON 4 PANEL OPEN/EJECT BUTTON ENCODER VOLUME BUTTON MUTE AUDIO BUTTON BUTTON PRESET MEMORY BUTTONS (M1~M6) BAND/LOUDNESS BUTTON 10 5 MP3 ENTER BUTTON 2 7 13 MP3 SEARCH MENU BUTTON AF BUTTON 6 8 15 REMOTE CONTROL RECEIVER DISPLAY BUTTON SUB-WOOFER BUTTON IX-BASS BUTTON 9 PTY BUTTON AUTOMATICALLY TUNING UP / DOWN SOURCE STORE / PRESET TRACK UP / DOWN BUTTON/ BUTTONS SUB-WOOFER SCAN BUTTON LEVEL CONTROL 16 11 14 ID3-TAG INFORMATION E-1 2. HANDLING COMPACT DISCS MOISTURE CONDENSATION On a rainy day or in a very damp area, moisture may condense on the lenses inside the unit. Should this occur, the unit will not operate properly. In such a case, remove the disc and wait for about an hour until the moisture has evaporated. NOTES ON CDs 1. [. . . ] 7) PRESET STATION BUTTONS Six numbered preset buttons store and recall stations for each band. Store a Station Select a band (if needed), then select a station. The preset number will appear in the display. Recall a Station Select a band (if needed). Press a preset button to select the corresponding stored station. 11) AUTOMATICALLY STORE / PRESET SCAN (AS/PS/ID3) Automatically Store Automatically select 6 strong stations and store them in the current band. Press AS/PS button for more than three seconds. The new stations replace stations already stored in that band. Preset Scan Scan stations stored in the current band. Press AS/PS button for less than 3 seconds. The unit will pause for ten seconds at each preset station. Press AS/PS button again to stop scanning when the desired station is reached. STEREO The unit will automatically pick up a stereo signal, when available. When in stereo mode, the ST icon appears in the display. When no stereo signal is available, the unit will automatically revert to mono operation, and no icon will be displayed. 3) LOCAL/DISTANT BUTTON (LOC) This feature is used to designate the strength of the signals at which the radio will stop during automatic tuning. "Distance" is the default setting, allowing the radio to stop at a broader range of signals. To set the unit to select only strong local stations during automatic tuning, use the volume control button until "Local" appears in the display. E - 12 9. CD PLAYER OPERATION INSERT AND EJECT CD Insert a CD label-side up with the unit turned on, and the disc will begin to play. Press the Eject button to stop CD play and eject the CD. The unit does not have to be turned on to eject the CD. PAUSE BUTTON Press the pause button to suspend disc play. [. . . ] AS/PS/ID3 Preset EQ CD Eject Display Clock, Spectrum Or animation or PTM/menu function Preset EQ CD Eject Display Clock, Spectrum Or animation or PTM/menu function Change to Radio or AUX IN No function CD TEXT Change to Radio or AUX IN MP3 Search ID3 Information 13. Numeric Key(1) (2) (3) (4) (5) (6) IX-Bass & PTY Function Preset station 1 Preset station 2 Preset station 3 Preset station 4 Preset station 5 Preset station 6 IX-Bass Pause Intro scan Repeat Random No Function No Function IX-Bass Pause Intro scan Repeat Random Folder Down Folder Up E - 21 13. SPECIFICATIONS CD PLAYER System Usable disc Sampling frequency No of quantization bits Frequency Number of channels S/N Ratio Compact disc audio system Compact disc 44. 1KHz 1bit 5-20, 000Hz 2 stereo 70dB RADIO SECTION FM Frequency Range Intermediate Frequency Usable Sensitivity Stereo Separation S/N Ratio 87. 5-108MHz 10. 7 MHz Better than 15dB at S/N 30 dB 25 dB at 1KHz 50 dB GENERAL Power Supply Polarity Speaker impedance Power Output DC 11 -14V Negative Ground 4 ohms 4x 80 Watts REMARK : Specifications subject to change without notice. E - 22 14. TROUBLE SHOOTING Before going through the check list, check wiring connection. If any of the problems persist after check list has been made, consult your nearest service dealer. Symptom No power Cause The car ignition is not on. Solution If the power supply is properly connected to the car accessory terminal, switch the ignition key to "ACC" The fuse is blown. Disc cannot be loaded or ejected Replace the fuse. Remove the disc in the player, then put a new one. Insert the compact disc with the label facing upward. Presence of CD disc inside the player. Inserting the disc in reverse direction. [. . . ]