User manual BOSS RPS-10

[. . . ] SEL Each press of this button switches among functions in the sequence described below. tuner mode: Tuning mode - Flat feature Reference Pitch Metronome mode: Rhythm Style - Beat - Tempo (Down)/ (Up) These change various settings. TAP Set the metronome's tempo by tapping this button in time with the beat. Speaker This plays the metronome sound, the reference tone, and the AccuPitch sound. [. . . ] Sounds arriving at the INPUT jack, MIX IN jack, and the built-in mic are not played through the speaker. When you're using Sound mode, tuning cannot be performed using the built-in mic (the built-in mic is disabled). When using battery power, if the RPS-10 remains in the state described below for approximately thirty minutes after it was turned on, the power will automatically be switched off. You can temporarily deactivate the Auto Power Off feature when you power up the RPS-10. Hold down [ ] and [ ] and press [ ] (Power button) to turn on the power. "OF" is displayed and the power comes on with the Auto Power Off feature deactivated. The Auto Power Off feature will be enabled the next time you turn on the power in the usual way. To prevent malfunction and/or damage to speakers or other devices, always turn down the volume, and turn off the power on all devices before making any connections. Once the connections have been completed, turn on power to your amp or other amplification system last. By turning on devices in the wrong order, you risk causing malfunction and/or damage to speakers and other devices. The tuning guide flashes when the battery begins to run down. replace the battery as soon as possible. * When turning the unit upside-down, place it on a soft cloth or the like so as to prevent damage to the panel. If you're tuning an acoustic instrument, use the built-in mic instead. To use the mic, make sure that nothing is connected to the INPUT or OUTPUT jacks, and place the RPS-10 near the instrument. * To prevent malfunction and/or damage to speakers or other devices, always turn down the volume, and turn off the power on all devices before making any connections. Open the battery compartment (located on the bottom of the unit) by sliding the cover toward OPEN. Remove the old battery from the battery compartment. * Make sure the "+" and "-" terminals of the battery are oriented correctly. Press [SEL], then press [ ] [ ] to choose the tuning mode (CHROMATIC, GUITAR, or BASS). [. . . ] * Make sure the "+" and "-" terminals of the battery are oriented correctly. Press [SEL], then press [ ] [ ] to choose the tuning mode (CHROMATIC, GUITAR, or BASS). If necessary, press [SEL] with [ ] and [ ] to make settings for Flat tuning and/or the reference pitch. When the setting has been made, press [SEL] a number of times until the flashing display ends. [. . . ]