User manual BOTEX DC-1216 DMX CONTROLLER

[. . . ] DC-1216 DMX CONTROLLER CONTROLS AND FUNCTIONS: 1. SCANNERS ­ allows you to select from up to 12 fixtures, consisting of 16 DMX channel banks or less. For example if SCANNER 1 button is selected the FADERs will operate channels 1 to 16, if SCANNER 6 is selected they will operate channels 81 to 96. If both 1 and 6 are selected the FADERS will assign the same values to both ranges of channels. [. . . ] Wait 1 second, then release the buttons. Note that this will delete all scenes, and if any chases have been programmed they will be deleted as well. Copy Bank: 1. This will copy the settings of one bank to another. When you have finished, exit programming mode. Delete Bank: 1. Press and hold down the AUTO / DELETE button. Press and hold down the MUSIC / BANK COPY button. When you have finished, exit programming mode. PROGRAMMING CHASES: (you must program banks and scenes before you can program chases) Program Chases: 1. This allows you to run up to 240 scenes from different banks in a sequential order. Select a chase to program by pressing one of the CHASE buttons. Repeat 4 and 5 until you have programmed all the banks and scenes you require into the selected chase. When you have finished, exit programming mode. Copy a Bank to a Chase: 1. This allows you to add whole banks to chases. Note that if you select a chase that already has scenes programmed into it, this will add the bank after the last scene you programmed. Select the bank you wish to add to the chase selected. Note that you can repeat steps 4 to 6 if you wish to add more than 1 bank. When you have finished, exit programming mode. Chase Editing ­ Adding a Step: 1. This allows you to insert a step into a chase at any point. Select the chase you wish to add step(s) to. The BANK UP and DOWN buttons can now be used to manually step through the chase selected in part 3. The LED display will count from 1 to the maximum number of steps in the chase showing the position of where you are in the chase. 6. If for example you wish to place an extra step between steps 16 and 17, use the BANK UP and DOWN buttons to select step 16, then press MIDI / REC. This will add a space for you to add the extra step. [. . . ] Moving the SPEED SLIDER again restores step rate control to normal. Notice that when the SPEED SLIDER is moved the step rate is displayed in seconds and minutes as it moves. The delay is shown on the LED display for a few seconds, and then reverts to normal once the SPEED SLIDER has stopped moving. You can change the banks whilst this is happening to step through other scenes. 4. Music Run: 1. [. . . ]