User manual BOTEX SD-10

[. . . ] Keep this manual with the unit, in order to consult it in the future. If the unit is sold or given to another operator, make certain that it always has its manual, to enable the new owner to read about its operation and re lative instructions. Warnings DO NOT make any inflammable liquids, water or metal objects enter the unit. Should any liquid be spilled on the unit, DISCONNECT the power supply to the unit immediately. STOP using the unit immediately In the event of serious operation problems and either contact your local dealer for a check or contact us directly. [. . . ] There are total 30 banks you can select, you may store up to 8 scenes into each bank. SCENE BUTTONS 1-8 7. Tap the Scene button to store your scene, all LEDs and the Segment Display will flash three times briefly indicating this operation, then the Segment Display will show the bank and the scene. Scanner buttons 1-12 8. Repeat steps 3-7until all desired scenes have been programmed into memory. Tap the Scanner button again to turn off its fader control. To assign another scanner(fixture), you may tap the corresponding Scanner button to turn on its fader control, then you may begin your programming again. 9 2. Operation Guide 2. 2 Programming Scenes Program 9. If you wish not continue your programming, press and hold down the Program button for three seconds to exit Program mode, the blinking light in the Segment Display goes out indicating this selection. EXAMPLE: Program 8 scenes with channel 1-8 at full in sequence into bank 2 and assign these scenes to scanner 2. 1. Tap the Scanner 2 button to turn on its fader control. Tap the Page Select button to select Page A. Select bank 2 using Bank Up/Down button. Tap the Scene 1 button to store the first scene. While holding down the Auto/Del button, tap the Scene button that stores the scene you wish to delete. When a programmed scene is deleted, all DMX channel in this scene is set to 0. 2. 2. 5 Delete all Scenes This function will reset all DMX channel to 0 output. Program 1. With the power off, press and hold down the Program and Bank Down buttons at a time. 2. Apply power again, all scenes should be cleared. 15 2. Tap the Bank Up/Down button to select the bank you wish to copy. 3. Tap the MIDI/Rec button. MIDI/Rec 4. Tap the Bank Up/Down button to select the bank you wish to copy to. 16 2. Operation Guide 2. 2. 6 Bank Copy Music/Bank Copy 5. Tap the Music/Bank Copy button, all LEDs and the Segment Display will flash three times briefly indicating the function has been completed. 6. Press the Program button for three seconds to exit Programming mode. 2. 3 Programming Chase You must program scenes before you can program chases, this function allows you to store up to 240 scenes into one chase. 1. Tap the Chase button to select the chase to program. [. . . ] A second tap of this button will deactivate this function. Use the Speed slider(or Tap Sync button) and Fade Time slider to adjust the current scenes to your desired effects. 4. Use the Bank Up/Down button to scroll through the chase to run all banks of scenes. 2. 5. 2 Auto Mode Auto/Del 1. Tap the Auto/Del button to activate Auto mode. [. . . ]