User manual BOWENS GM125

[. . . ] · Operate the unit without a safe grounded (earthed) AC supply. DO: Modelling Power Control Flash Duration (t=0. 5) (Full power) Flash Power Control Modelling Lamp Ready Indication User Replaceable Flash Tube Photocell Audio Ready Signal Recommended Modelling Lamps Weight SPECIFICATIONS Dimensions (w x l x h) Travel-Pak Compatible · Switch power off and disconnect from the supply before changing modelling bulb or flash tube. · Disconnect the supply before changing the fuse. Never replace with a fuse of a different rating. [. . . ] DISCONNECT THE MAINS LEAD, WHEN CHANGING MODELLING LAMPS & FLASH TUBES. For mains operation, the mains switch (page 4) should be in the upper position (I). For battery operation the switch should be in the lower position (II). NOTE: When operated from a battery source, the modelling functions are not available. Travel-Pak The Esprit Gemini is great in the studio, but what if you need to work on location?Thanks to this handy battery pack, your Bowens Esprit Gemini Monoblocs can leave the studio to go on location anytime, anywhere!Able to power two monoblocs simultaneously with a total power of up to 1500Ws, the Travel-Pak is capable of bringing a 125Ws unit to full charge as fast as 1 second, and can offer in excess of 1, 000 flashes on a single charge. With a fast/slow charge option to prolong battery life as well as a stylish carry bag offering protection from the elements and up to 3 inches of water, no location photographer should be without this unique power pack. Dimensions (mm) - 180(l) x 120(w) x 175(h) Weight - 4. 1kg Travel-Pak (BW-7630) Also available for the Bowens Travel-Pak: BW-7635 Travel-Pak Boost Battery. BW-7632 Travel-Pak to Gemini Spare Cable. BW-1227 Bowens Universal 2Amp SLA Charger. Ensure the power source is OFF. Connect the unit using the appropriate cabling. If using a battery source, ensure the connector locks are fully tightened. Switch the power source on, then switch on the Esprit Gemini. The unit will charge and indicate it is ready for use by illuminating the Green READY light. Press the TEST button to check the unit fires. Mounting Mount the Esprit Gemini unit on selected support system. The mounting bush on the 'L' bracket allows for two possible ways of mounting to the stand / support (Fig. 3). Method B may be found useful if the light is required to point down. Figure 3 A B www. bowens. co. uk 5 8 www. bowens. co. uk Fitting the Modelling Lamp Switch off and disconnect from the supply. Screw modelling lamp into ES lampholder in the centre of the reflector. Note: It is recommended that a Photoflood or Halostar bulb with a maximum wattage of 275W is used. The manufacturer will not accept liability on the use of any lamp with a greater wattage than 275W. Modelling Lamp Control With the modelling lamp control switch (Fig. 1. 3) in the upper position, the modelling light is on HALF power. With the modelling lamp set to the centre the modelling light will stay OFF, and with the switch set in the lower position the modelling lamp stays on FULL power. Fuse Flash Power Control The flash power output is variable over two f-stops from full to 1/4 power. The power settings are denoted in steps of 1/6 stop. [. . . ] A range of reflectors is available for the Esprit Gemini unit. To fit, slide the neck of the reflector over the front of the unit. Align the three pegs on the reflector with the three slots in the retaining ring. To remove reflector, pull back Latch Knob (page 4), turn the reflector fully anti-clockwise and withdraw. [. . . ]