User manual BRANDT AD426XE1

[. . . ] These products do not contain any asbestos based components. Qxd 26/02/04 16:05 Page 3 Throughout this manual, indicates safety recommendations, indicates advice to help you make the best use of your oven T he controls on your hood 3-speed model Fig. 1 GB l ll lll Slow speed Medium speed Fast speed Lighting Ultra-quiet electronic model 1 2 3 Lighting Stop Start 1 Slow speed 2 Medium speed 3 Fast speed In the case of a kitchen heated by a device connected to a chimney (for example a stove) the "recycling" version of the hood should be installed. Do not use the hood without metal filters. [. . . ] 5 All of our appliances can be used in recycling mode. In this case, you should add an active carbon filter which will keep in odours. A ssembling your hood The hood must be installed in conformity with the applicable regulations concerning the ventilation of premises. In France, these regulations are detailed in DTU 61. In particular, the evacuated air must not be channelled into a duct used to evacuate fumes from appliances using gas or other combustible fuels. Disused ducts may only be used after approval from a competent specialist. The minimum distance between the cooking surface and the lowest part of the hood must be 70 cm. If the instructions for the hob installed under the hood specify a distance of more than 70 cm, this requirement must be respected. - Place the assembly template against the wall: fig. 2 - Draw a vertical line on the wall in order to perfectly line up your hood with your cooking appliance. - Draw a mark on the vertical line at 70 cm (minimum) from your hob. - Fit the plastic smoke deflector to the wall also placing this against the ceiling. Take care to centre the deflector vis-à-vis the vertical line drawn on the wall (fig. - Prepare your chimney taking care to place the vents toward the top to ensure that they are visible (fig. - Fit the upper part to the plastic deflector. - Adjust the length of the telescopic chimney by bringing down the lower part and fitting it into the top of the hood. Before carrying out any work, the power supply to the hood must be turned off, either by unplugging it or by using the circuit breaker switch, 1. Unscrew then change the E14-40W bulb (fig. The power supply to the hood must be turned off either by removing the plug or by using the circuit breaker switch before you remove the metal filters. After cleaning, the metal filters must be refitted in conformity with the instructions. FILTER CARTRIDGE Remove the protective film before using the filter cartridge for the first time. This component plays an important part in ensuring the effectiveness of your hood. [. . . ] You should order these filters from your dealer (quoting the reference shown on the ID plate located inside the hood) and note the date the filter was changed. To clean the body and the lighting port, you should use only commercial household cleaning products diluted in water and then rinse using clean water, drying with a soft cloth. This filter traps odours and must be changed at least once a year (depending on how intensively you use it), in order to avoid all risks of fire. You should order the filters from your dealer (quoting the reference number shown on the I. [. . . ]