User manual BRANDT TI313

[. . . ] Check the filters Ensure they are clean and properly positioned (see "Maintenance and cleaning"). 9. At the end of the washing programme At the end of the programme the dishwasher will automatically stop. 2. Check that there is rinse aid and salt 3. Load the dishes Remove any scraps of food. [. . . ] Pull the lower basket out and arrange the saucepans, plates and cutlery in it. Pull the upper basket out and arrange the plates, saucers, glasses and cups etc. Slide the baskets back into the machine. 10. Switch off the dishwasher Switch off the dishwasher by pressing the On/Off push button and open the door. Wait a few minutes before removing the dishes; in this way they will be cooler and the drying will be improved. Empty the lower basket first and then the upper one; this will avoid water dripping from the upper basket onto the dishes in the lower one. 4. Ensure that the spray arms can rotate freely. Measure out detergent Add the required amount of detergent into the dispenser according to the "Washing programmes" chart. Close the detergent dispenser lid. When the washing programme has finished, it is recommended that the dishwasher is unplugged and the water tap turned off. Arrange items on and underneath the fold-down cup racks so that water can reach all surfaces. Light items (plastic bowls etc. ) should be loaded in the upper basket and arranged so they do not move. Before closing the door, ensure that the spray arms can rotate freely. US64 US70 Adjusting the height of the upper basket If washing very large plates (over 27 cm and up to 31 cm in diameter) you can load them in the lower basket after moving the upper basket to the higher position. To move to the higher position proceed as follows: 1. Move the front runner stops (A) of the upper basket outwards and slide the basket out. Refit the basket in the higher position and replace the stops (A) in their original position. RC01 A When the top basket is in the higher position it will only take plates up to 20 cm in diameter and you will not be able to use the raised cup racks. After loading your machine always close the door, as an open door can be a hazard. 27 Hints for test centres Before starting any test it is necessary to fill completely with salt the salt container and with rinse aid the rinse aid dispenser Test standard: Reference programme: Load: Rinse aid selector: Detergent dosage: EN 50242 Bio 50°c with prewash 12 standard place settings position 5 25 g in the dispenser 5 g on the dispenser lid US57 UI49 UI72 Arrangement upper basket Arrangement lower basket Arrangement cutlery basket Technical specifications Dimensions Width Height Max depth Max depth with open door Voltage 59. 6 cm 81. 8 - 87. 8 cm 57. 5 cm 111. 4 cm 230 V - 50 Hz 200 W 2100 W 2300 W 50 kPa (0. 5 bar) 800 kPa (8 bar) 12 place settings Electrical connection Motor rating during wash Power of heating element Overall power Water supply pressure Minimum Maximum Capacity 28 Protection against flooding In order to prevent water floods, the machine has been provided with two devices, having the following characteristics: 1. In the water inlet hose: The water supply hose is fitted with a safety device, which prevents water from entering the machine should the inner hose split, due to wear. It operates even with the machine off The problem is signalled by a red indicator which appears in the window (B - ). If this happens, close the water tap and have the hose replaced. [. . . ] If this happens, close the water tap and have the hose replaced. The retaining ring (A - ) must be properly fitted so as to avoid water leaks. Only for water supply hoses with Lock-fast safety device to prevent inadvertent loosening. To detach the hose press yellow lever (C - ) and turn the retaining ring anticlockwise . A 2 B A C B 1 CA13 2. [. . . ]