User manual BRAUN 1508 UNIVERSAL

[. . . ] For easy recycling this shaver is equipped with a screw mechanism in the plug socket. This mechanism should only be activated at the end of the useful life of the shaver and should be carried out only by a Braun Service Centre. Description Charging pilot light Longhair trimmer switch On/off switch Switch lock «lock» Pop-out longhair trimmer Cutter block Shaving foil frame Foil protection cap Cleaning brush Cordless shaving/charging When charging the shaver for the first time, connect the shaver to the mains (100 ­ 240 V), via the mains lead, and charge with the switch 3 set at «off», until the charging pilot light 1 goes off. The shaver should be discharged through normal shaving until it stops completely. [. . . ] When you first use the shaver or the shaver runs out of power) you can connect the shaver directly to an outlet in order to shave immediately. If the shaver should, however, not run immediately, leave it plugged in with switch 3 set to «off», for approximately 1 minute. Thereafter, you can shave with the mains lead plugged into the outlet. Shaving directly via the special charging cord while connected to outlets below international standard voltages (e. Stretch your skin with your free hand (b). Guide the shaver smoothly against the direction of beard growth, applying only gentle pressure. Longhair trimming To use pop-out longhair trimmer 5, push switch 2 to setting «longhair trimmer». the longhair trimmer allows easy and exact trimming of the side burns (c). The longhair trimmer can be switched on and off during shaving. Switching the shaver off Push the on/off switch 3 back all the way to setting «off». important: After every shave replace the foil protection cap 8 on the foil frame 7. Switch lock To avoid accidentally switching on the shaver and discharging the cell unit, the switch lock should be turned on when travelling. Push switch 4 all the way down to the setting «lock». Cleaning and maintenance After every shave, remove the foil frame 7 (d) and tap out lightly. Brush out the cutter block 6 with the cleaning brush 9 (e). Do not clean the shaving foil with the cleaning brush 9 to avoid damaging it. Approximately every four weeks clean the space between the longhair trimmer 5 and the shaver with the cleaning brush 9. Clean the cutter block 6 with Braun cleaning spray to maintain your shaver's top shaving performance and to keep it hygienic. after every cleaning replace the foil protection cap 8 on the foil frame 7. Changing the shaving parts The shaving foil frame 7 should be held at the two grooved surfaces and pulled off (d). [. . . ] This guarantee extends to every country where this appliance is supplied by Braun or its appointed distributor. This guarantee does not cover: damage due to improper use, normal wear or use as well as defects that have a negligible effect on the value or operation of the appliance. The guarantee becomes void if repairs are undertaken by unauthorised persons and if original Braun parts are not used. To obtain service within the guarantee period, hand in or send the complete appliance with your sales receipt to an authorised Braun Customer Service Centre. [. . . ]