User manual BRAUN 3390

[. . . ] Active, 4-way moving massage rollers stimulate the skin before and after the hair is removed to offset the pulling sensation. The shaver head 8 is specially designed for a fast and close shave of underarms and bikini line. important · This appliance must never be used near water (e. Keep the appliance out of the reach of children. [. . . ] Put on the epilation head and make sure that the 4-way moving pain softener 1 is in place. Plug the cord connector 6 into the socket 5 and plug the transformer plug 7 into an electrical outlet. 1 To turn on the appliance, slide switch (4) to setting «2» («2» = normal speed, «1» = reduced speed). for optimum performance hold the appliance at a right angle (90°) against your skin. Guide it in a slow, continuous movement without pressure against the hair growth, in the direction of the switch. The SoftLiftTM tips will make sure that even flat lying hair is lifted and removed thoroughly at the root. As hair can grow in different directions, it may also be helpful to guide the appliance in different directions to achieve optimum results. Both rollers of the 4-way moving pain softener should always be kept in contact with the skin, allowing the pulsating movements to stimulate and relax the skin for a gentler epilation. 3 Leg epilation Epilate your legs from the lower leg in an upward direction. When epilating behind the knee, keep the leg stretched out straight. 4 Underarm and bikini line epilation Please be aware that especially at the beginning these areas are particularly sensitive to pain. with repeated usage the pain sensation will diminish. For more comfort, ensure that the hair is at the optimum length of 2-5 mm. Before epilating, thoroughly clean the respective area to remove residue (like deodorant). When epilating the underarm, keep your arm raised up so that the skin is stretched and guide the appliance in different directions. As skin may be more sensitive directly after epilation, avoid using irritating substances such as deodorants with alcohol. Cleaning the epilation head 5 After epilating, unplug the appliance and clean the epilation head: First take off the 4-way moving pain softener 1 and brush out the rollers. 6 To clean the tweezer element, use the cleaning brush dipped into alcohol. Turn the product around and clean the tweezers with the brush while turning the barrel manually. 7 Remove the epilation head by pressing the release buttons 3 on the left and right and pull it off. Give the top of the housing a quick clean with the brush. Place the epilation head and the 4-way moving pain softener back on the housing. [. . . ] Have the shaving foil frame and the cutter block replaced when you notice a reduced shaving performance even after cleaning the shaver head. This product conforms to the EMC-Requirements as laid down by the Council Directive 89/336/EEC and to the Low Voltage Regulation (73/23 EEC). Either by repairing or replacing the complete appliance as we may choose. This guarantee extends to every country where this appliance is supplied by Braun or its appointed distributor. [. . . ]