User manual BRAUN 550

[. . . ] Do not exchange or manipulate any part of it. Do not use an extension cord with this appliance. Close supervision is necessary when this appliance is used by, on, or near children or invalids. Use this appliance only for its intended use as described in this manual. [. . . ] Comfort setting switch «sensitive» Setting the shaver head according to your comfort needs. Do not expose the shaver to temperatures higher than 122 °F / 50 °C for extended periods of time. ⷠUsing the special cord set (11), connect the shaver to an electrical outlet with the motor switched off and charge it for at least one hour. This may vary according to your beard growth. ⷠIf the rechargeable battery has run out of power (discharged), you may also shave by connecting the shaver to an electrical outlet via the special cord set. The shaver head is in full swing, freely follows the contours of your skin to provide more comfort. The shaver head is semi-fixed for more control. The shaver head is fixed for full control and precise handling in hard to reach areas. Long hair trimmer To trim sideburns, moustache or beard, slide the long hair trimmer (4) upwards. Tips for the perfect shave For best shaving results, Braun recommends you to follow 3 simple steps: 1. At all times, hold the shaver at right angles (90°) to your skin. Stretch your skin and shave against the direction of your beard growth. Model 560: During charging or when using the shaver, the respective green battery segment will blink. When fully charged, all green segments will light up continuously, provided the shaver is switched on or connected to an electrical outlet. The hand-held unit should be detached from the power supply cord before cleaning. The shaver should not be used until it has dried. Rinsing the shaving head under running water after each shave is an easy and fast way to keep it clean: · Switch the shaver on (cordless) and rinse the shaver head under hot running water. You may use liquid soap without abrasive substances. Rinse off all foam and let the shaver run for a few more seconds. ⷠNext, switch off the shaver, press the foil release buttons (3) to remove the shaver foil (1) and cutter block (2). Then leave the disassembled shaving parts to dry. ⷠIf you regularly clean the shaver under water, then once a week apply a drop of light machine oil onto the long hair trimmer and shaver foil. [. . . ] please call 1-800-Braun 11 (800-272-8611) to be referred to the authorized Braun Service Center closest to you. This warranty does not cover foil and cutter cassette or damage resulting from accident, misuse, abuse, dirt, water, tampering, unreasonable use, normal wear, servicing performed or attempted by unauthorized service agencies or failure to provide reasonable and necessary maintenance, including recharging. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you. This warranty gives you specific legal rights, and you may also have other legal rights which vary from state to state. [. . . ]