User manual BRAUN 570 CC QUICK GUIDE

[. . . ] Do not expose to direct sunlight and cigarette smoking nor store it over a radiator. Do not refill the cartridge and use only original Braun refill cartridges. Shaver 7 Shaver foil 8 Cutter block 9 Foil release buttons 10 Long hair trimmer 11 Comfort setting switch «sensitive» 12 Shaver-to-station contacts 13 On/off switch 14 Shaver display 15 Cleaning light (yellow) 16 Replacement light for shaving parts 17 Shaver power socket 18 Special cord set 19 Etui Prior to first use, you have to connect the shaver to an electrical outlet using the special cord set (18) or alternatively, proceed as follows: Installing the Clean&Renew station · Using the special cord set (18), connect the station power socket (5) to an electrical outlet. Carefully remove the lid from the cartridge. [. . . ] Comfort setting switch «sensitive» Setting the shaver head according to your comfort needs. The shaver head is in full swing, freely follows the contours of your skin to provide more comfort. After each shave, return the shaver to the Clean&Renew station and proceed as follows: · Do not interrupt the cleaning process, as it leaves the shaver wet and not fit for use. The shaver head is semi-fixed for more control. The shaver head is fixed for full control and precise handling in hard to reach areas. Long hair trimmer To trim sideburns, moustache or beard, slide the long hair trimmer (10) upwards. When cleaning is finished, the yellow cleaning light will go off and the shaver is ready for use. A cleaning cartridge should be sufficient for about 30 cleaning cycles. When the level indicator (1) has reached the «min» mark, the remaining fluid in the cartridge is sufficient for about 5 more cycles. Then the cartridge should be replaced, when used daily approx. The hygienic cleaning cartridge contains alcohol, which once opened will naturally evaporate slowly into the surrounding air. Each cartridge, if not daily used, should be replaced after approximately 8 weeks. The cleaning cartridge also contains lubricates, which may leave residual marks on the shaver head after cleaning. However, these marks can be removed easily by wiping gently with a cloth or soft tissue paper. Rinsing the shaver head under running water is an alternative way to keep the shaver clean, especially when traveling: · Switch the shaver on (cordless) and rinse the shaver head under hot running water. You may use liquid soap without abrasive substances. Rinse off all foam and let the shaver run for a few more seconds. ⷠNext, switch off the shaver, press the foil release buttons (9) to remove the shaver foil (7) and cutter block (8). Then leave the disassembled shaving parts to dry. ⷠIf you regularly clean the shaver under water, then once a week apply a drop of light machine oil onto the long hair trimmer (10) and shaver foil (7). The following quick cleaning is another alternative cleaning method: · Press the foil release buttons (9) to lift the shaver foil (do not remove the foil completely). 5­10 seconds so that the shaved stubbles can fall out. [. . . ] In the interest of protecting the environment, please do not dispose of the product in the household waste at the end of its useful life. Disposal can take place at a Braun Service Centre or at appropriate collection points provided in your country. The cleaning cartridge can be disposed with regular household waste. This guarantee does not cover: damage due to improper use, normal wear and tear (e. [. . . ]