User manual BRAUN 570CC

[. . . ] However, we recommend to follow the procedure described here: · Using the special cord set (1), connect the mains socket of the Clean&RenewTM station (7) to an electrical outlet. Carefully remove the lid from the cartridge. Slowly close the housing by pushing it down until it locks. The display for cleaning fluid (6) will show how much cleaning fluid is in the cartridge: a) cleaning solution sufficiently available b) up to 7 cleanings left c) new cartridge required Make sure the foil protection cap (9) is removed from the shaver. [. . . ] Your shaver is now clean and ready for use. If the shaver is locked into the Clean&RenewTM station, push the «start cleaning» button (2) to release the shaver and take it out. Switch positions off = (switch is locked) Press and push up the switch to operate the shaver: on = Shaving with the pivoting head (the pivoting cutting system automatically adjusts to every contour of your face). Fix = Shaving with the pivoting head locked at an angle (to permit shaving in difficult areas, e. We recommend that you shave before washing, as the skin tends to be slightly swollen after washing. Stretch your skin and shave against the direction of beard growth. ⷠTo maintain 100% shaving performance, replace your foil and cutter block, when the replacement light (18) comes on (after about 18 months), or when worn. Shaving with the cord If the shaver is completely discharged and you do not have the time to recharge in the Clean&RenewTM station, you may also shave with the shaver connected to the mains via the special cord set. Automatic cleaning After each shave, return the shaver to the Clean&RenewTM station and proceed as described above in the section «Before shaving». All charging and cleaning needs are then taken care of. With daily use, a cleaning cartridge should be sufficient for about 30 cleaning cycles. The hygienic cleaning solution cartridge contains alcohol which, once opened, will naturally evaporate slowly into the surrounding air. Each cartridge, if not used daily, should be replaced after approximately 8 weeks. Quick cleaning Press the foil release buttons (12) to lift the shaver foil (do not remove the foil completely). 5­10 seconds so that the shaved stubbles can fall out. Thorough manual cleaning Manual cleaning is recommended only when the Clean&RenewTM station is not available, e. remove the shaver foil and tap it out on a flat surface. Using the brush, clean the inner area of the pivoting head. [. . . ] After you have replaced the shaving parts (foil and cutter block), use a ball-pen to push the reset button (19) for at least 3 seconds to reset the counter. While doing so, the replacement light blinks and goes off when the reset is complete. The manual reset can be done at any time. The green charging light (16) shows that the shaver is being charged. [. . . ]