User manual BRAUN 8795

[. . . ] However, we recommend to follow the procedure described here. ⷠUsing the special cord set (1), connect the mains socket of the Clean&Charge station (7) to the mains. Carefully remove the lid from the cartridge. Slowly close the housing by pushing it down until it locks. [. . . ] Your shaver is now clean and ready for use. If the shaver is locked into the Clean&Charge station, push the «start cleaning» button (2) to release the shaver and take it out. Switch positions 0 = Off (switch is locked) Press and push up the switch to operate the shaver: 1 = Shaving with the pivoting head The pivoting cutting system automatically adjusts to every contour of your face. 2 = Shaving with the pivoting head locked at an angle (to permit shaving in difficult areas, e. Tips for the perfect shave We recommend that you shave before washing, as the skin tends to be slightly swollen after washing. hold the shaver at right angles (90°) to the skin. Stretch your skin and shave against the direction of beard growth. To ensure optimal shaving performance, replace the shaver foil and cutter block when it is indicated on the shaver display or when the parts are worn or at least every 18 months. Shaving with the cord If the shaver is completely discharged and you do not have the time to recharge in the Clean&Charge station, you may also shave with the shaver connected to the mains via the special cord set. Automatic cleaning After each shave, return the shaver to the Clean&Charge station and proceed as described above in the section «Before shaving». All charging and cleaning needs are then taken care of. With daily use, a cleaning cartridge should be sufficient for about 30 cleaning cycles. The hygienic cleaning solution cartridge contains alcohol which, once opened, will naturally evaporate slowly into the surrounding air. Each cartridge, if not used daily, should be replaced after approximately 8 weeks. Thorough manual cleaning Manual cleaning is recommended only when the Clean&Charge station is not available, e. remove the shaver foil and tap it out on a flat surface. Using the brush, clean the cutter block and the inner area of the pivoting head. If you do not use the Clean&Charge station for a longer period of time, you should apply a drop of light machine oil onto the shaver foil. Replacing the cartridge After having pressed the lift button (4) to open the housing, wait for a few seconds before removing the used cartridge. Before discarding the used cartridge, make sure to close the openings using the lid of the new cartridge, since the used cartridge will contain contaminated cleaning solution. [. . . ] To protect the environment, do not dispose of the appliance in the household waste at the end of its useful life. Open the housing as shown, remove and dispose of the batteries at your retail store or at appropriate collection sites according to national or local regulations. The cartridge can be disposed with regular garbage. This product conforms to the EMC-Requirements as laid down by the Council Directive 89/336/EEC and to the Low Voltage Regulation (73/23 EEC). [. . . ]