User manual BRAUN 8970

[. . . ] Close supervision is necessary when this appliance is used by, on, or near children or invalids. Use this appliance only for its intended use as described in this manual. Do not use attachments not recommended by the manufacturer. The appliance should never be exposed to temperatures of less than 32 ºF / 0 ºC and more than 105 ºF/+ 40 ºC for longer than a few hours. [. . . ] When fully discharged, you may also shave with the shaver connected to an electrical outlet via the special cord set. Model 8975: When the shaver is fully charged, all five charging lights (7) will light up (20% per light), provided the shaver is connected to an electrical outlet or switched on. Model 8970: The green single charging light (7) shows that the shaver is being charged. When fully charged, the charging light flashes or goes off. If later on, the charging light comes on again, this indicates that the shaver is being recharged to maintain its full capacity. Switch positions off = (switch is locked) Press and push up the switch to operate the shaver: on = Shaving with the pivoting head (the pivoting cutting system automatically adjusts to every contour of your face). Fix = Shaving with the pivoting head locked at an angle (to permit shaving in difficult areas, e. It can take up to 14-21 days for your beard to adjust to the new shaving system. Shave before washing your face or taking a shower, as skin tends to swell after washing. The drier the skin, the closer the shaving results will be. Stretch the skin and shave against the direction of beard growth. To maintain 100% shaving performance, replace your foil and cutter block, when the replacement light (9) comes on (after about 18 months), or when worn. The red low charge light (8) flashes when the battery capacity has dropped below 20%, provided the shaver is switched on. For easy cleaning after each shave, switch the shaver off. Press the release buttons to lift the shaver foil (do not remove the foil completely). 5­10 seconds so that the shaved stubbles can fall out. Then remove the shaver foil and tap it out on a flat surface. Using the brush, clean the inner area of the pivoting head. However, do not clean the shaver foil nor the cutter block with the brush as this may damage them. Put a drop of light machine oil onto the long hair trimmer and the shaver foil. Replacement light for shaving parts / Reset To maintain 100% shaving performance, replace your foil and cutter block, when the replacement light for shaving parts (9) comes on (after about 18 months) or when worn. Change both parts at the same time for a closer shave with less skin irritation. [. . . ] This warranty does not cover foils, cutter blocks or damage resulting from accident, misuse, abuse, dirt, water, tampering, unreasonable use, normal wear, servicing performed or attempted by unauthorized service agencies or failure to provide reasonable and necessary maintenance, including recharging. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you. This warranty gives you specific legal rights, and you may also have other legal rights which vary from state to state. 2 year limited warranty (foil and cutter block excluded) In the event a Braun Shaver fails to function within 2 years from date of purchase, because of defects in material or workmanship, and the consumer returns the unit to an authorized service center, Braun Canada, will, at its option, either repair or replace the unit without additional charge to the consumer. [. . . ]