User manual BRAUN BS 8985

[. . . ] When the battery is fully charged, the charging light lights permanently. 5877 and 5878 models: The 3 segments of the green charging light indicate the charging level by thirds. When fully charged, all 3 segments of the charging light shine permanently. [. . . ] Shaver foil Cutter block Release button On/off switch («start/stop») Long hair trimmer Charging lights (green) Low-charge light (red) (5878/5877/5876/5875 models only) 8 Replacement light for shaving parts 9 Reset button 10 Special cord set 1 2 3 4 5 6 7 (5878/5877/5876/5875 models only) The red low-charge light flashes when the battery capacity has dropped below 20%, provided the shaver is switched on. Turn on the shaver ("start"): The pivoting cutting system automatically adjusts to every contour of your face. Using the special cord set, connect the shaver to an electrical outlet with the motor switched off. ⷠWhen charging for the first time, leave the shaver to charge continuously for 4 hours. ⷠOnce the shaver is completely charged, discharge the shaver through normal use. Maximum battery capacity will only be reached after several charging/discharging cycles. ⷠIf the rechargeable batteries are discharged, you may also shave by connecting the shaver to an electrical outlet via the special cord set. We recommend that you shave before washing, as the skin tends to be slightly swollen after washing. Stretch the skin and shave against the direction of beard growth. then recharge the shaver to full capacity. Do not expose the shaver to temperatures higher than 50°C for extended periods of time. This appliance is provided with nickel-hydride rechargeable batteries. To protect the environment, do not dispose of this appliance in the household waste at the end of its useful life. Open the housing as shown below, remove and dispose of the batteries at your retail store or at appropriate collection sites according to national or local regulations. About every four weeks, clean the cutter block with Braun cleaning agents. Put a drop of light machine oil onto the long hair trimmer and the shaver foil. Replacement light for shaving parts / Reset To maintain 100% shaving performance, replace your foil and cutter block, when the replacement light for shaving parts (8) comes on (after about 18 months) or when worn. Change both parts at the same time for a closer shave with less skin irritation. [. . . ] Replacement light for shaving parts / Reset To maintain 100% shaving performance, replace your foil and cutter block, when the replacement light for shaving parts (8) comes on (after about 18 months) or when worn. Change both parts at the same time for a closer shave with less skin irritation. Within the guarantee period we will eliminate, free of charge, any defects in the appliance resulting from faults in materials or workmanship, either by repairing or replacing the complete appliance as we may choose. [. . . ]