User manual BRAUN CRUZER3

[. . . ] Do not exchange or manipulate any part of it. Otherwise there is risk of electric shock. 1 2 3 4 4a 4b 5 6 7 8 9 Foil protection cap Shaver foil Cutter block Styler Wide shaper (28 mm) Narrow shaper (14 mm) Charging light On/off switch Trimming attachment Beard length setting Special cord set Using the special cord set, connect the shaver to an electrical outlet with the motor switched off. When charging for the first time, leave the shaver to charge continuously for 4 hours. [. . . ] Stretch the skin and shave against the direction of beard growth. ⷠTo maintain 100% shaving performance, replace your foil and cutter block at least every 18 months or when worn. This appliance may also be used in the shower. Before doing so, make sure that it is unplugged!When using it in the shower, we recommend applying shaving foam or gel. Press the blue rib to push out the styler (4). the narrow shaper (4b) precisely defines lines and edges (d): Ideal for precise contouring. To use the narrow shaper, push out the styler and turn it 180°. Frequent use of the styler may reduce the battery capacity. Place the trimming attachment onto the shaver foil (2) and press it against the shaver housing until it snaps into place with a click. Press the beard length selector (8) (e) and slide it up in order to set the desired beard length (length settings from top to bottom 1. Activate the on/off switch and trim against hair growth by guiding the blue transparent comb part over the skin. Always unplug the appliance before cleaning. regular cleaning ensures better shaving performance. Rinsing the shaving head after each shave under running water is an easy and fast way to keep it clean: · Switch the shaver on (cordless) and rinse the shaving head under hot running water (f). A natural based soap may also be used provided it contains no particles or Rinse off all foam and let the shaver run for a few more seconds. Next, switch off the shaver, remove the shaver foil and the cutter block. Then leave the disassembled shaving parts to dry. Alternatively, you may clean the shaver using the brush provided (g): · Using the brush, clean the cutter block and the inner area of the shaver head. However, do not clean the shaver foil with the brush as this may damage the foil. [. . . ] This guarantee extends to every country where this appliance is supplied by Braun or its appointed distributor. This guarantee does not cover: damage due to improper use, normal wear and tear (e. The guarantee becomes void if repairs are undertaken by unauthorised persons and if original Braun parts are not used. To obtain service within the guarantee period, hand in or send the complete appliance with your sales receipt to an authorised Braun Customer Service Centre. [. . . ]