User manual BRAUN FLEX XP II SYSTEM

[. . . ] With normal use the shaver will be charged automatically after every cleaning in the Clean&Charge (see separate instructions). ⷠThe green charging light indicates that the shaver is being charged. However, the maximum battery capacity will only be reached after several charging/discharging cycles. [. . . ] ) Preserving the batteries In order to maintain the optimum capacity of the rechargeable batteries, the shaver has to be fully discharged (by shaving) every 6 months approximately. During this time clean only manually and not in the Clean&Charge. then recharge the shaver to full capacity again. Do not expose the shaver to temperatures of more than 50 °C for longer periods of time. This product conforms to the EMCRequirements as laid down by the Council Directive 89/336/EEC and to the Low Voltage Regulation (73/23 EEC). This appliance is provided with nickelcadmium batteries. To protect the environment, do not dispose of this appliance in the household waste at the end of its useful life. disposal can take place at a Braun Service Centre or appropriate collection sites. However, if you prefer to dispose of the product yourself, remove the batteries as shown. During the automated cleaning process, the shaver is switched on and off at intervals to obtain best cleaning results. Since the specially formulated cleaning fluid contains a small amount of oil, the cleaning procedure also fulfills the lubrication needs of the shaver. important · Only use the power supply cord set supplied with the shaver. ⷠIn order to avoid any leakage of the cleaning fluid, place the appliance on a flat, stable surface. Do not tip, move suddenly or transport in any way if a cleaning cartridge is installed. ⷠDo not place the appliance in a mirror cabinet, nor store it over radiators, nor place it on polished or laquered surfaces. When cleaning the shaver, its protection cap should be removed. Carefully remove the lid from the cartridge. Slowly close the housing by pushing it down until it locks. [. . . ] To release it, push the start/release button. A cleaning cartridge should be sufficient for about 30 cleaning cycles. When the level indicator (4) has reached the «min» mark, the remaining fluid in the cartridge is sufficient for about 5 more cleaning cycles. [. . . ]