User manual BRAUN VITALSCAN PLUS BP 1650

[. . . ] Regular blood pressure measurements taken at home can provide your doctor with valuable information on your normal blood pressure values under actual «everyday» conditions. The World Health Organisation (WHO) has set up the following standard blood pressure values when measured at resting pulse. Blood pressure (mmHg) SYS = systole = upper value DIA = diastole = lower value To ensure accurate measuring results, carefully read these use instructions. ⷠThis product is intended for household use only. [. . . ] While measurement is in progress, do not move or speak. At the end of the measurement, a beep sounds and the reading is displayed: Upper (systolic) value Lower (diastolic) value Pulse Otherwise the product will turn off automatically after 2 minutes. If at any time, you want to stop the measurement, press the red start/stop button. After each measurement, the blood pressure monitor automatically stores the reading in memory. Please note that stored data will be erased if changing batteries takes longer than 15 seconds. Then press the memory button («memo») (B). Repeatedly pressing the memory button will call up one by one all stored readings. ⷠTo exit the memory mode, turn the device off by pressing the start/stop button. BP 1650: The readings of the last 20 measurements with time and date are stored in memory. The lower display line successively shows date, time and pulse of the respective measurement. The lower display line shows «Time» and flashing digits in the «hour» position. To adjust the hours, repeatedly push the «memo» button. Again, repeatedly push the «memo» button to adjust the minutes. ⷠPush button (C) again to adjust the date: The lower display line shows «Date» and flashing digits in the month position. Push button (C) again: The day digits will flash. Again, repeatedly push the «memo» button to adjust the day. Otherwise the device automatically turns off after 2 minutes and activates the settings made so far. Clean the product with a soft, slightly damp cloth. Stains on the cuff (G) can be carefully removed with a damp cloth. If used according to the use instructions, periodic recalibration is not required. [. . . ] Please do not dispose of the product in the household waste at the end of its useful life. Disposal can take place at a Braun Service Centre or at appropriate collection points provided in your country. Within the guarantee period we will eliminate, free of charge, any defects in the appliance resulting from faults in materials or workmanship, either by repairing or replacing the complete appliance as we may choose. This guarantee extends to every country where this appliance is supplied by Braun or its appointed distributor. [. . . ]