User manual BRAUN Z60

[. . . ] Warning Your shaver is provided with a special cord set with an integrated Safety Extra Low Voltage power supply. Do not exchange or manipulate any part of it. Otherwise there is risk of electric shock. This appliance is not intended for use by children or persons with reduced physical, sensory or mental capabilities, unless they are given supervision by a person responsible for their safety. [. . . ] Once the shaver is completely charged, discharge the shaver through normal use. Maximum battery capacity will only be reached after several charging/discharging cycles. First, remove the trimming attachment (7): Using your thumbs, press against the side clips of the trimming attachment so that they swing off in the direction of the arrows (a). The floating foil frame automatically adapts to your skin surface for a close, smooth shave. for best results: · Always shave before washing your face. ⷠAt all times, hold the shaver at right angles (90°) to the skin (b). ⷠStretch the skin and shave against the direction of beard growth. ⷠFor pre-shaving after a few days of not having shaved, use the wide shaper (4a) to pre-cut long hairs. For a close, smooth shave, finish with the foil. ⷠTo maintain 100% shaving performance, replace your foil and cutter block at least every 18 months or when worn. This appliance is suitable for use in a bath or shower. When using it in the shower, we recommend applying shaving foam or gel. Using the rotating styler The wide shaper (4a) evenly cuts and trims large areas (c). it is ideal for shaping sideburns , moustaches and partial short beards. The wide shaper is provided with safety rips and a gliding strip for less irritation and easy gliding. Press the blue stripes to push up the rotating styler (4). While stretching the skin, guide the wide shaper against the direction of hair growth. The narrow shaper (4b) precisely defines lines and edges (d), being ideal for precise contouring. [. . . ] However, do not clean the shaver foil with the brush as this may damage the foil. Replacing the shaving parts To maintain 100% shaving performance, replace your foil and cutter block at least every 18 months or when worn. Change both parts at the same time for a closer shave with less skin irritation. (Shaver foil and cutter block: 20 BL) Preserving the batteries In order to maintain the optimum capacity of the rechargeable batteries, the shaver has to be fully discharged (by shaving) every 6 months approximately. [. . . ]