User manual BREIL 7T62

[. . . ] [If the chronograph hands are not in the "0" position, follow the procedure below to set them to the 0 position] Press button for 2 seconds to select the chronograph hand (s) to be adjusted this for 2 seconds. Selection is made in the following order by pressing button The hand moves quickly if button , is kept pressed. After all adjustments are completed, push the crown back into the normal position in accordance with a time signal, checking that the hour and minute hands for time display indicate the current time. Before setting the date, be sure to set the time. [. . . ] â· It is necessary to adjust the date at the and of February and 30 day months. Turn the crown clockwise until the desired date appears 3. Push the crown back into the normal position. Note: Do not set the date between 9:00 p. Otherwise, the date may not change properly. The chronograph can measure up to 12 hours in 1/20 second increments. â· The measured time is indicated by the four chronograph hands that move independently of the hands for time display. â· When the measurement reaches 12 hours, the chronograph automatically stops counting. Split / split Release / Reset Chronograph hour hand Ex: 2 hours, 30 minutes and 10. However, if it persists for any length of time, the watch should be checked by the shop where it was purchased or by the nearest Authorised Service Centre. Temperature Do not leave the watch exposed to direct sunlight or temperature extremes for long periods of time. Long exposure, in fact, may adversely affect the operation of the watch and actually shorten battery life, causing it to gain or lose time and affect its other functions. Impact This watch can withstand normal everyday impacts and shocks and those normally imparted by non-contact sports. Serious damage, however, may result if the watch is dropped or subjected to severe shock. Magnetic fields This watch is antimagnetic up to 60 gauss, and is therefore not affected by magnetic fields produced by normal domestic appliances. If used near strong magnetic fields, its operation may be temporarily affected. Static electricity The integrated circuits present inside the watch are sensitive to static electricity. If the watch is exposed to intense electrical fields, the time display may temporarily lose some of its accuracy. [. . . ] Static electricity The integrated circuits present inside the watch are sensitive to static electricity. If the watch is exposed to intense electrical fields, the time display may temporarily lose some of its accuracy. Chemicals and gases Avoid wearing the watch in the presence of strong gases or chemical substances. Parts of the watch may discolour, dissolve or even break if brought into contact with benzol or petroleum based products such as solvents, thinners, detergent, adhesives etc. [. . . ]