User manual BREIL AW00

[. . . ] The alarm is turned off automatically once it has sounded or vibrated. The auxiliary time (alarm set time) is then switched over to the current time display and runs concurrently with the primary time. When primary time is different from auxiliary time: Alarm is ON When primary time is the same as auxiliary time: Alarm is OFF (When pressing button for the first time, pressing it continuously for at least 0. 5 seconds will cause the auxiliary time to advance in 1 minute increments. [. . . ] In such cases, switch from the vibration alarm to the sound alarm. [When Using the sound alarm] · If you wear your watch tightly on your wrist, it may be difficult to hear the alarm sound. Wear the watch somewhat loosely to hear the alarm sound better. ⷠWhen it is difficult to hear the alarm sound due to high levels of surrounding noise and so forth, switch to the vibration alarm. ⷠSwitch to the vibration alarm when desiring to be informed of the time by the alarm in a manner that does not inconvenience those around you. * Refer to the alarm identification mark on the display to determine whether the watch is set to the sound alarm or vibration alarm. When the watch is not worn or when carried in a pocket or other clothing so that the watch falls to a temperature lower than that when normally worn, the vibration motor low temperature power saving feature is activated. This feature automatically turns off the vibration alarm function. When this vibration motor low temperature power saving feature has been activated, the second hand switches to irregular 2-second interval movement. When this happens warm up the watch body by putting the watch on your arm in the manner it is worn normally. The watch will then switch from irregular 2-second interval movement and return to normal operation. As the battery approaches the end of its services life, the second hand will switch to 2-second interval movement, in which the second advances two seconds at the time, informing the wearer that the battery is nearly worn out. when this happens , have the battery replaced promptly. When the low battery warning feature is activated, the sound alarm function and vibration alarm function will no longer operate. - In order to prevent water coming into contact with the internal mechanism, never pull the crown out when the watch is wet. - If any watches designed for sportswear or use in water come into contact with salt water or heavy sweating, they should be rinsed in fresh water and dried thoroughly. Must be kept away from water and moisture Average water resistance. Can withstand spray, sweat, light rain, washing, etc. During daily use Can be worn while swimming but not diving Suitable for skin-diving. * Always keep the crown in its normal position. - Contact with water may cause a deterioration in the quality of some leather straps. - As internal parts of the watch can retain moisture, when the outside temperature is lower than the inside, the watch glass may mist-up. [. . . ] The watch case and strap may discolour if they come into contact with mercury from a broken thermometer or other equipment. Keeping the watch clean Use an absorbent soft cloth to clean off any dirt or damp from the watch glass. Wearing the watch when the strap or back of the case is dirty can cause skin irritation. cleaning the watch strap: · Metal bands: use a toothbrush and soapy warm to wash the dirt off. [. . . ]