User manual BREVILLE BES250

[. . . ] Breville is a registered trademark of Breville Pty. ABN 98 000 092 928 Breville Customer Service Centre Australian Customers PO Box 22 Botany NSW 2019 AUSTRALIA Customer Service: 1300 139 798 Fax (02) 9384 9601 Email Customer Service: askus@breville. com. au Breville Customer Service Centre Café Venezia Espresso / Cappuccino Machine Instructions BES250 BES250S New Zealand Customers Breville Customer Service Centre Private Bag 94411 Greenmount Auckland, New Zealand Customer Service: 0800 273 845 Fax 0800 288 513 Email Customer Service: askus@breville. com. au www. breville. com. au © Copyright. 2008 Due to continual improvements in design or otherwise, the product you purchase may differ slightly from the one illustrated in this booklet. Model: BES250/BES250S Issue 1/08 Contents Page Breville Recommends Safety First Know Your Breville Café Venezia Espresso / Cappuccino Machine Operating Your Breville Café Venezia Espresso / Cappuccino Machine Coffee Making Tips Care and Cleaning Trouble Shooting Chart Coffees to Try Notes 4 6 8 13 15 17 19 20 Congratulations on the purchase of your new Breville Café Venezia Espresso / Cappuccino Machine 2 3 Breville recommends safety first We at Breville are very safety conscious. [. . . ] If you require a larger coffee, add the hot water first and then brew the coffee. Place the 1 or 2 cup filter basket into the group handle. Use the smaller filter for 1 cup larger filter for 2 cups and the Filling the Water Tank Open up the water tank lid and remove the water tank. Fill with cold water to the maximum mark and replace in the machine. Close the water tank lid. Use 1 level measure of ground espresso coffee for the 1 cup filter basket and 2 level measures for the 2 cup filter basket. It is important to use the correct amount of coffee for each filter as the filter perforations have been constructed to utilise the pressure in the machine to extract optimal flavour with each brewing. Clean any excess ground coffee from the rim of the filter holder to ensure a proper fit into the group head. Priming the Group head Before placing the filter holder into position, it is recommended to run a short flow of water through the group head. Place a container or empty cup under the group head, or allow water to flow straight into the drip tray. With the filter holder removed, prime the group head by turning the `SELECTOR CONTROL' to the "ESPRESSO' function for approximately 5 seconds. A pumping noise will be heard during this operation, and water will run through the group head. 9 8 Operating your Breville Café Venezia Espresso / Cappuccino Machine (continued) Inserting the Filter holder Place the filter holder underneath the group head so that the handle is aligned with the insert graphic. Insert the filter holder up into the group head and rotate the handle to the right until resistance is felt or until it can no longer be rotated. This will be at an approximate 90° angle to the machine. Operating your Breville Café Venezia Espresso / Cappuccino Machine (continued) Emptying the Filter holder Remove the filter holder from the group head by rotating the filter holder to the left until it releases. To empty the used coffee grounds, turn the filter holder upside down in a bin and gently tap out the coffee puck (used coffee grounds should be thrown away with domestic waste and not down the sink which may block drains). Remove the filter by pressing on the `EJECT' button on the underside of the filter holder. Rinse the filter and filter holder with water and allow to dry. The machine remains ready for brewing and maintains a constant heating temperature as long as the `POWER' switch is left `On'. If the temperature should drop, the red hEaTIng light will illuminate and the machine will automatically heat up to the correct brewing temperature. Brewing Coffee Ensure the `SELECTOR CONTROL' is in the `Standby' position and plug the power cord into a 230/240V power outlet and switch on. Press the `POWER' button `On'. The `POWER' button surround will illuminate. The red `HEATING' light will turn off when the machine has reached the correct temperature. As soon as the red `HEATING' light turns off, the machine is heated up. Ensure the drip tray and filter holder are in place. Place one or two pre-heated cups beneath the filter holder outlet. Set the `SELECTOR CONTROL' to the `ESPRESSO' position. After a few seconds, the extraction of espresso begins. [. . . ] · If the steam wand becomes blocked, wait for the machine to cool before using the `CLEANING TOOL' to unblock the opening. · If the steam wand continues to be blocked, the tip of the steam wand can be removed by using the spanner in the middle of the CLEANING TOOL. · Soak the tip in hot water before using the pin on the cleaning tool to unblock. Replace the tip back onto the steam wand and secure with the CLEANING TOOL. [. . . ]