User manual BREVILLE BKE410

[. . . ] · Do not place the kettle on or near a gas burner, electric element or in or near a heated oven. · To protect against electric shock, do not immerse the kettle base, switch area, power base, power supply cord or plug in water or allow moisture to come in contact with these parts. · Always ensure the kettle switch is in the 'OFF' position, then turn the power off at the power outlet and remove the plug from the power outlet before attempting to move the appliance, when the appliance is not in use and before cleaning and storing. · Do not remove the kettle from the power base during operation. [. . . ] Do not remove the kettle from the power base during operation. Ensure the kettle has switched to `OFF' position after the water has boiled, before removing the kettle from the power base. Note 2. Ensure that the lid is closed and locked firmly into place. Place the kettle firmly onto the power base. Plug the power cord into the 230/240V power outlet and switch `ON'. Press the ON/OFF switch down to turn ON the kettle. The power `ON' light will illuminate. Operation of your kettle 1. To fill the kettle with water, remove it from the power base and open the lid by pressing the lid release button on the handle. Fill with the desired amount of water. Always fill the kettle to between the minimum (MIN ) and maximum ( MAX ) marks on the exterior of the water window on the kettle. Too little water will result in the kettle switching `OFF'. Switch "OFF" at the power point and allow kettle to cool before refilling. The safety device will automatically reset when the kettle has cooled down. Filling above the maximum mark on the exterior of the kettle may result in boiling water splashing from the kettle. Note DO NOT PRESS THE LID RELEASE BUTTON ON THE HANDLE TO OPEN THE LID DURING AND AFTER OPERATION. THIS MAY RESULT IN BOILING WATER SPLASHING FROM THE KETTLE. POUR OUT ALL THE HOT WATER FROM THE KETTLE BEFORE OPENING THE LID TO REFILL. 7 Operating your Breville Moda 1 Litre Kettle 4. The kettle will automatically switch `OFF' once the water has boiled. Lift the kettle from the power base and pour the water. Take care to hold the kettle level, especially when filled to the maximum level. To re-boil it may be necessary to wait for a few seconds to allow the control to reset. The kettle should be stored on its power base when not in use. The power outlet should be switched off and the power cord unplugged from the power outlet when not in use. This kettle must only be used with the power base supplied. [. . . ] Do not use chemical, steel wool, or abrasive cleaners to clean the outside of the kettle Note Removal of mineral deposits Due to the large surface area of the concealed element interior base, discolouration due to mineral deposits from tap water may appear more obvious by leaving a brown stain on the base. The concealed element is made from high quality stainless steel. Any brown stains appearing are the result of mineral deposits and are not rust. Note Storage Ensure the kettle is switched off, cleaned and dried before storing. Ensure that the lid is closed and locked firmly into place. [. . . ]