User manual BREVILLE BREADMASTER

[. . . ] Check the contents: • Instant Cappuccino maker • Milk tank • Cleaning jug 8 CLEANING TRAY 3 7 5 6 15 14 2 CLEAN/GO COFFEE SHOT STOP 11 3. Position the Instant Cappuccino on a stable flat surface, close to a mains power socket and out of the reach of children. The Instant Cappuccino produces steam, so avoid areas under cupboards or other furniture/decorations that may be damaged. INITIAL CLEANING To ensure that residue left by the manufacturing process is removed, flush the machine with clean water as described in the following procedure: 1. [. . . ] The following parts can be washed in a dishwasher if desired: 1. Cleaning tray GENERAL CLEANING – UNIT AND PARTS DISPENSING NOZZLE (figure C) It is advisable to periodically remove the nozzle so that it can be soaked and cleaned thoroughly. IMPORTANT: Allow the unit to cool completely before removing the dispensing nozzle. Simply pull the nozzle towards you from the machine. 5 STOP C CLEAN/GO COFFEE SHOT 2. Wash in warm soapy water, rinse and dry. STOP 2 1 3. Push the nozzle back onto the dispensing pipe, making sure that the outlet points downwards. 6 CLEAN/GO COFFEE SHOT 4 3 MILK PIPE (figure D) With the control dial in the CLEAN/GO!position wipe the milk pipe clean with a damp cloth. COFFEE CHAMBER (figure E) Any granules that have not been removed by the cleaning process use a dry cloth to dislodge the granules and wipe the camber clean. Wipe the outside of the unit with a damp soapy cloth then wipe dry with a dry soft cloth. If the Instant Cappuccino is not going to be used for a period of time the water tank can be emptied. Ensure the machine is turned off and unplugged and has been allowed to cool before commencing. The red ready light will come on when the machine is at operating temperature. Problem TROUBLESHOOTING GUIDE Possible Causes and Corrective Action 1. Remove the funnel and if necessary break up the coffee by gently prodding with a narrow blade such as the handle of a teaspoon. Turn the control dial to the COFFEE SHOT position and back to the STOP position twice. If coffee has solidified in the mechanism you may need to apply slightly more force than normal. Flush the machine with clean water Slide the cover shut and lift the funnel from the machine. Coffee was left in the coffee dispenser and the internal mechanism and it has solidified. 10. The machine makes excessive noise when the control dial is initially turned to the CLEAN/GO!position and dispenses very strong coffee. Cappuccino may continue to dispense for a few seconds after the control dial has been moved to the STOP position. It is also possible to mix milk and water with a ratio of 50:50. [. . . ] If this appliance is fitted with a moulded BS1363/A 13 amp plug, the fuse should be rated at 13 amps and be ASTA approved to BS1362. If the fuse in a non-rewirable plug needs to be changed, the fuse cover must be refitted. The appliance must not be used without the fuse cover fitted. In the event of the plug being unsuitable, it should be changed and an appropriate plug fitted as detailed below. [. . . ]