User manual BREVILLE URN10

[. . . ] We at Breville are very safety conscious. We design and manufacture consumer products with the safety of you, our valued customer foremost in mind. In addition, we ask that you exercise a degree of care when using any electrical appliance and adhere to the following precautions. READ THESE INSTRUCTIONS BEFORE OPERATING AND SAVE FOR FUTURE REFERENCE. [. . . ] · Before use fully unwind power cord. · If supply cord, plug or actual appliance becomes damaged in any way, return the entire appliance to the nearest authorised Breville Service Centre for examination, replacement or repair. · Any maintenance other than cleaning should be performed at an authorised Breville Service Centre. KNOW YOUR BREVILLE URN 1. Capacity (Urn6 - 6 litres, Urn10 - 10 litres) Stainless steel body 1800 watt concealed element Non-drip tap with 2 way pouring action External water gauge Variable heat control Locking lid with ergonomic handles 9. Automatic boil dry cut out protects against overheating (safety reset button is under the base) Power `on' and `heating' lights 10. Steam holes (on top of lid) 7. 5. 1. 2. 4. 6. 10. 2 3 OPERATING YOUR BREVILLE URN BEFORE FIRST USE It is recommended that before the first use, the Urn is filled to the maximum level, boiled and water discarded. Firstly fully unwind power cord from base. Place the Urn on a dry level surface and position the drip tray at the front of the Urn (tilt the Urn back and slide the drip tray under to secure in place fig 1). OPERATING YOUR BREVILLE URN (CONTINUED) Do not fill above the maximum fill line on the external water gauge as boiling water may splash out from the Urn. NOTE! NOTE! The lid should always be fitted and locked into position when in use. Use caution when pouring water from your Urn, as boiling water will scald. Do not open the lid when in operation as steam may escape from the top. 4. After filling the Urn, ensure that the lid is replaced and locked into position. Plug the power cord into a 230/240V power outlet and switch on. The red `on' light will illuminate. Turn the variable heat control to `Hi' for fast boiling (fig 3). When the unit has boiled, select the desired setting from `Low' to 7 to maintain temperature. The heating light will illuminate on and off maintaining the temperature selected. Fig 4 Steam may escape from the steam holes on top of the Urn. [. . . ] Switch the appliance to off, switch the power off at the power outlet and allow the Urn to cool. Press the safety reset button under the base before refilling (fig 7). The safety device will then be reset and the Urn is ready for use. Fig 7 CARE AND CLEANING Always switch the appliance to off, switch the power off at the power outlet and then remove the plug before cleaning. [. . . ]